Gigabyte GA-8I915P-G (rev. 2.x) [2/18] Ác åé

IDE RAID Drives Configuration (GigaRAID) - 2 -

Ác

Åé

¤¤

¤å

Configuring IDE RAID Hard Drive(s) (Controller GigaRAID (IT8212))

To set up IDE RAID hard drive(s), follow the steps below

(1) Install IDE hard drive(s) in your computer.

(2) Configure GigaRAID controller mode and boot sequence in BIOS Setup.

(3)* Configure RAID set in RAID BIOS.

(4) Make a floppy disk containing the IDE RAID controller driver

(5) Install the IDE RAID controller driver during OS installation.

Before you begin

Please prepare:

(a) Two IDE hard drives (to ensure optimal performance, it is recommended that you use two hard

drives with identical model and capacity). If you do not want to create RAID with the GigaRAID controller,

you may prepare only one hard drive.

(b) An empty formatted floppy disk.

(d) Driver CD for your motherboard.

(1) Installing IDE hard drive(s) in your system

Attach one end of the IDE cable to the rear of the IDE hard drive and the other end to IDE port(s) controlled

by the GigaRAID controller on the motherboard. (To ensure that your IDE CD-ROM drive can work

properly, please connect it to the IDE port that is controlled by the Southbridge, not the GigaRAID controller).

Then connect the power connector from your power supply to the hard drive(s).

"*" Skip this step if you do not want to create RAID array on the IDE controller