Bomann GS 176 230L [22/25] Peration

03/2012

9) Cover the holes left by the removed screws with the

blanking plates. Re-secure the door handle on the

other side. Cover screws with the blanking plates.

11) Check the door is aligned horizontally and vertical-

ly. Re-adjust the adjustable feet.

10) Replace and secure the lid of the Upright Freezer

with the two top screws and the three rear screws from

step 1.

Check if the door is arranged vertical as well as horizontal, so that a smooth opening and closing of

the door is ensured.

STARTUP / OPERATION

Prior to first use

ATTENTION

After transport, the device should be left standing for 4 hours in order for the oil to be collected in the

compressor.

Nonobservance could cause damage to the compressor and hence result in failure of the

device. This would void your warranty claim.

• Clean the interior of the device including all accessory parts located inside.

Connect the device to the mains supply

IMPORTANT

• The device must be earthed properly. For this purpose the plug of the mains cable has been fitted

with the intended lead.

• Contact an electrician if the plug does not fit in the wall socket.

• In case you disconnect the device or in case of power failure: Wait for 5 minutes before restarting

the device.

Turning on

Turn on the device by connecting the plug to a wall socket.

The thermostat control panel controls the temperature inside the freezer compartment and is located

on the top cover plate.

Thermostat of the freezer compartment

If you press the or button, you can select the temperature ranging from -24°C to -15°C. If you

press the or button once, the temperature will increase or decrease 1°C, until the required tem-

perature is displayed.

Please keep in mind that the temperature changes with the ambient temperature (of the location), with

the frequency of opening the door and the amount of food in the device.