Moser Protect Limited Edition [8/72] English

ENGLISH

· As additional safety measure, it is recommended that a tested residual

current appliance (RCD) with a residual operating current of not more

than 30 mA be installed in the bathroom circuit. Ask the electrician who

installed your appliance for advice.

· Never operate the appliance without a filter in the air inlet cover.

· Disconnect from the mains before cleaning or servicing the appliance.

· When the appliance is new, sparking may occur at the collector of the

motor inside the appliance. This phenomenon disappears after a brief

operating period and does not indicate that there is any impairment of

the appliance’s operational safety.

· Never use the appliance if it is defective, if it has fallen onto the floor

or if the mains cable is damaged. A damaged mains cable may only be

replaced with an original replacement cable by an authorised Service

Centre or another similarly qualified person, in order to avoid hazards.

· Repairs may only be performed at an authorised Service Centre using

original parts. Only specialists properly trained in the handling of elec-

tro technical appliances may repair electrical equipment.

· Only use accessories recommended by the manufacturer.

· When disconnecting the appliance from the mains, never pull on the

mains cable or on the appliance itself.

· Do not hold the appliance by the mains cable to carry it and do not

use the cable as a handle.

· Do not wind the mains cable around the appliance.

· Keep the mains cable and appliance away from hot surfaces.

· Make sure that the mains cable is not twisted or kinked when used

and stored.

· When using a diffuser, never set the hair-dryer to a high temperature

as this could result in the overheating of the diffuser or hair-dryer.

· Never insert or allow objects to fall into the openings of the appliance.

· Never use the appliance where aerosol (spray) products are being

used or where oxygen is released.

· The appliance is safety insulated and radio screened. It meets the

requirements of EU Directive 2004/108/EC regarding electromagnetic

compatibility and EC Low Voltage Directive 2006/95/EC.

· We are not liable for damage caused as a result of improper use or

failure to observe these operating instructions.