Makita УШМ (болгарка) DGA452Z аккумуляторная +Сумка PGH-170100 [10/16] Operation

To remove wheel guard, follow the installation

procedure in reverse.

Installing or removing depressed center

grinding wheel/Multi-disc

007219

WARNING:

• Always use supplied guard when depressed

center grinding wheel/Multi-disc is on tool. Wheel

can shatter during use and guard helps to reduce

chances of personal injury.

Mount the inner flange onto the spindle. Fit the

wheel/disc on the inner flange and screw the lock nut

onto the spindle.

To tighten the lock nut, press the shaft lock firmly so that

the spindle cannot revolve, then use the lock nut wrench

and securely tighten clockwise.

007220

To remove the wheel, follow the installation procedure in

reverse.

WARNING:

Only actuate the shaft lock when the spindle is not

moving.

OPERATION

WARNING:

• It should never be necessary to force the tool. The

weight of the tool applies adequate pressure.

Forcing and excessive pressure could cause

dangerous wheel breakage.

• ALWAYS replace wheel if tool is dropped while

grinding.

• NEVER bang or hit grinding disc or wheel onto

work.

• Avoid bouncing and snagging the wheel,

especially when working corners, sharp edges etc.

This can cause loss of control and kickback.

• NEVER use tool with wood cutting blades and

other sawblades. Such blades when used on a

grinder frequently kick and cause loss of control

leading to personal injury.

CAUTION:

• Make the depth of a single cut up to 5 mm. Adjust

pressure on the tool so that the tool does not slow

down during the operation.

• After operation, always switch off the tool and wait

until the wheel has come to a complete stop

before putting the tool down.

• If the tool is operated continuously until the battery

cartridge has discharged, allow the tool to rest for

15 minutes before proceeding with a fresh battery.

Grinding and sanding operation

007221

ALWAYS hold the tool firmly with one hand on housing

and the other on the side handle. Turn the tool on and

then apply the wheel or disc to the workpiece.

In general, keep the edge of the wheel or disc at an

angle of about 15 degrees to the workpiece surface.

During the break-in period with a new wheel, do not

work the grinder in the B direction or it will cut into the

workpiece. Once the edge of the wheel has been

rounded off by use, the wheel may be worked in both A

and B direction.

1. Lock nut wrench

2. Shaft lock

1. Lock nut

2. Depressed

center grinding

wheel/Multi-disc

3. Inner flange

Makita УШМ (болгарка) DGA452Z аккумуляторная +Сумка PGH-170100 [10/16] Operation

Содержание

Похожие устройства