Makita УШМ (болгарка) DGA452Z аккумуляторная +Сумка PGH-170100 [12/16] Maintenance

WARNING:

• When using an abrasive cut-off / diamond wheel,

be sure to use only the special wheel guard

designed for use with cut-off wheels. (In European

countries, when using a diamond wheel, the

ordinary guard can be used.)

• NEVER use cut-off wheel for side grinding.

• Do not "jam" the wheel or apply excessive

pressure. Do not attempt to make an excessive

depth of cut. Overstressing the wheel increases

the loading and susceptibility to twisting or binding

of the wheel in the cut and the possibility of

kickback, wheel breakage and overheating of the

motor may occur.

• Do not start the cutting operation in the workpiece.

Let the wheel reach full speed and carefully enter

into the cut moving the tool forward over the

workpiece surface. The wheel may bind, walk up

or kickback if the power tool is started in the

workpiece.

• During cutting operations, never change the angle

of the wheel. Placing side pressure on the cut-off

wheel (as in grinding) will cause the wheel to crack

and break, causing serious personal injury.

• A diamond wheel shall be operated perpendicular

to the material being cut.

MAINTENANCE

CAUTION:

• Always be sure that the tool is switched off and the

battery cartridge is removed before attempting to

perform inspection or maintenance.

• Never use gasoline, benzine, thinner, alcohol or

the like. Discoloration, deformation or cracks may

result.

007222

The tool and its air vents have to be kept clean.

Regularly clean the tool's air vents or whenever the

vents start to become obstructed.

Replacing carbon brushes

001145

Remove and check the carbon brushes regularly.

Replace when they wear down to the limit mark. Keep

the carbon brushes clean and free to slip in the holders.

Both carbon brushes should be replaced at the same

time. Use only identical carbon brushes.

Insert the top end of slotted bit screwdriver into the

notch in the tool and remove the holder cap cover by

lifting it up.

007226

Use a screwdriver to remove the brush holder caps.

Take out the worn carbon brushes, insert the new ones

and secure the brush holder caps.

007223

Reinstall the holder cap cover on the tool.

To maintain product SAFETY and RELIABILITY, repairs,

any other maintenance or adjustment should be

performed by Makita Authorized Service Centers,

always using Makita replacement parts.

1. Brush holder

cap

2. Screwdriver

1. Holder cap

cover

2. Screwdriver

1. Limit mark

1. Exhaust vent

2. Inhalation vent

Makita УШМ (болгарка) DGA452Z аккумуляторная +Сумка PGH-170100 [12/16] Maintenance

Содержание

Похожие устройства