Makita УШМ (болгарка) DGA452Z аккумуляторная +Сумка PGH-170100 [9/16] Assembly

− Battery cartridge replacing signal

− When the remaining battery capacity is low,

the indicator lamp lights up during operation

earlier than that of high battery capacity.

− Accidental re-start preventive function

− Even if the battery cartridge is inserted on

the tool with the slide switch in the "I (ON)"

position, the tool does not start. In this

situation, the lamp flickers slowly. It indicates

that the accidental re-start preventive

function is at work.

− To start the tool, first slide the slide switch

toward the "O (OFF)" position and then slide

it toward the "I (ON)" position.

Shaft lock

007216

CAUTION:

• Never actuate the shaft lock when the spindle is

moving. The tool may be damaged.

Press the shaft lock to prevent spindle rotation when

installing or removing accessories.

Switch action

007217

CAUTION:

• Before inserting the battery cartridge into the tool,

always check to see that the slide switch actuates

properly and returns to the "OFF" position when

the rear of the slide switch is depressed.

To start the tool, slide the slide switch toward the "I

(ON)" position. For continuous operation, press the front

of the slide switch to lock it.

To stop the tool, press the rear of the slide switch, then

slide it toward the "O (OFF)" position.

ASSEMBLY

CAUTION:

• Always be sure that the tool is switched off and the

battery cartridge is removed before carrying out

any work on the tool.

Installing side grip (handle)

007225

CAUTION:

• Always be sure that the side grip is installed

securely before operation.

Screw the side grip securely on the position of the tool

as shown in the figure.

Installing or removing wheel guard

(For depressed center wheel, multi disc /

abrasive cut-off wheel, diamond wheel)

For tool with locking screw type wheel guard

007218

WARNING:

• When using a depressed center grinding

wheel/Multi-disc, flex wheel, wire wheel brush, cut-

off wheel or diamond wheel, the wheel guard must

be fitted on the tool so that the closed side of the

guard always points toward the operator.

• When using an abrasive cut-off / diamond wheel,

be sure to use only the special wheel guard

designed for use with cut-off wheels. (In European

countries, when using a diamond wheel, the

ordinary guard can be used.)

Mount the wheel guard with the protrusion on the wheel

guard band aligned with the notch on the bearing box.

Then rotate the wheel guard to such an angle that it can

protect the operator according to work. Be sure to

tighten the screw securely.

1. Wheel guard

2. Bearing box

3. Screw

1. Slide switch

1. Shaft lock

Makita УШМ (болгарка) DGA452Z аккумуляторная +Сумка PGH-170100 [9/16] Assembly

Содержание

Похожие устройства