Makita УШМ (болгарка) DGA452Z аккумуляторная +Сумка PGH-170100 [8/16] Functional description

FUNCTIONAL DESCRIPTION

CAUTION:

• Always be sure that the tool is switched off and the

battery cartridge is removed before adjusting or

checking function on the tool.

Installing or removing battery cartridge

013993

CAUTION:

• Always switch off the tool before installing or

removing of the battery cartridge.

• Hold the tool and the battery cartridge firmly

when installing or removing battery cartridge.

Failure to hold the tool and the battery cartridge

firmly may cause them to slip off your hands and

result in damage to the tool and battery cartridge

and a personal injury.

To remove the battery cartridge, slide it from the tool

while sliding the button on the front of the cartridge.

To install the battery cartridge, align the tongue on the

battery cartridge with the groove in the housing and slip

it into place. Insert it all the way until it locks in place

with a little click. If you can see the red indicator on the

upper side of the button, it is not locked completely.

CAUTION:

• Always install the battery cartridge fully until the

red indicator cannot be seen. If not, it may

accidentally fall out of the tool, causing injury to

you or someone around you.

• Do not install the battery cartridge forcibly. If the

cartridge does not slide in easily, it is not being

inserted correctly.

Battery protection system

The tool is equipped with a battery protection system.

This system automatically cuts off power to the motor to

extend battery life.

The tool will automatically stop during operation if the

tool and/or battery are placed under one of the following

conditions:

• Overloaded:

The tool is operated in a manner that causes

it to draw an abnormally high current.

In this situation, turn the tool off and stop the

application that caused the tool to become

overloaded. Then turn the tool on to restart.

If the tool does not start, the battery is

overheated. In this situation, let the battery

cool before turning the tool on again.

• Low battery voltage:

The remaining battery capacity is too low

and the tool will not operate. In this situation,

remove and recharge the battery.

NOTE:

The overheat protection works only with a battery

cartridge with a star mark.

012128

Indication lamp with multi function

007224

Indication lamps are located in two positions.

When the battery cartridge is inserted on the tool with

the slide switch positioned in the "O (OFF)", the

indication lamp flickers quickly for approximately one

second. If it does not flicker so, the battery cartridge or

indication lamp may be broken.

− Overload protection

− When the tool becomes overloaded, the

indication lamp lights up. When the load on

the tool is reduced, the lamp goes out.

− If the tool continues to be overloaded and the

indication lamp continues to light up for

approximately two seconds, the tool stops.

This prevents the motor and its related parts

from being damaged.

− In this situation, move the slide switch to the

"O (OFF)" position once. And then move it to

the "I (ON)" position again to restart.

1. Star marking

1. Button

2. Red indicator

3. Battery cartridge

1. Indication lamp

Makita УШМ (болгарка) DGA452Z аккумуляторная +Сумка PGH-170100 [8/16] Functional description

Содержание

Похожие устройства