VTS VENTUS PRO PVS PO 30 AC [4/34] General information and safety instructions transport and storage

3 4

OIMM – VENTUS PRO

! For the units which are equipped with freon installation - before installing the device, check

the applicable regulations related to the obligations of the heat pump owner (an operator) in

relation to the need to register the freon installation (see the F-Gas Act)

! The owner of the heat pump (operator) is obliged to create a Product Card where all inspections,

repairs or modications to the device are recorded.

The VENTUS PRO can be delivered as fully assembled, assembled in sections or in packages, placed on closed

palettes, containing elements to be assembled on-site by the Manufacturer Authorized Service. This manual

does not contain instructions and guidelines on assembly of the unit.

Delivery of AHUs elements, in the closed, properly marked and not broken palettes is going to belong to customer

after signing of consignment note by client representative.

Open of closed palettes by customer before arrival of Authorized VTS Service is connect with take-over of full

responsibility for contents and completeness of delivery.

Right after delivery of the unit check the condition of the package and examine if all necessary elements have

been delivered - according to the attached specication and consignment note.

Unloading packages with AHU subassemblies, transport of the packages to the assembly location

and transport of AHU blocks and elements to the assembly location should be carried out using special equipment

and qualied staff.

Packages onsite must be stored on hardened, dry and protected against any precipitation place. Hardened

surfaces are understood as at, leveled and hard surface, which does not change its properties under inuence

of atmospheric conditions

Packages containing AHU elements should be stored away from places where operate mechanical devices

(vehicles, cranes and other construction machinery). They should be stored in places where they will not be

subject to any mechanical damages, humidity, aggressive chemical agents, uids, dusts and other external

agents which may deteriorate their condition.

Air handling units are inspected prior to dispatch for good condition and carefully loaded. Special care must be

taken while unloading the units.

Air handling units are generally damaged during transportation and loading / unloading, especially when being

lifted by a crane. Small units can be transported by hand-powered pallet truck or by forklift truck. While hoisting

or lowering, proper lifting equipment (slings and spreaders properly selected

on the ground of the size and weight of the section) should be used not to damage the unit. Safety precautions

should also be taken not to tilt and not to drop the unit.

GENERAL INFORMATION AND SAFETY INSTRUCTIONS TRANSPORT AND STORAGE

» TYPICAL LIFTING EQUIPMENT