Thomas CAT & DOG XT [39/56] Cleaning

Cleaning the fresh water tank (only for spray extraction)

Remove the fresh water tank by lifting out of the appliance.

Take off the lid of the fresh water tank by pulling it up and empty the

tank of any remaining water.

Clean the fresh water tank and its lid with clean, warm water to remove

any cleaning agent residue, which may be corrosive.

Put the lid back on the fresh water tank.

Lower the fresh water tank into the rear of the appliance.

If the suction filter was removed, place it back in the waste water

tank.

Only for wet vacuuming and spray extraction: If the spray extraction

insert was removed, lower it into the waste water tank. Make sure

that the float switch can move freely.

Insert the two foam filters. Close the two parts of the aqua filter lid

until you see and hear them latch into place.

Close the aqua filter. To do this, place the aqua lter lid in the two

holders on the waste water tank and gently push the aqua lter down

until you hear the unlocking tab latch into place.

If heavily soiled, you can remove the ejector for cleaning by turning

the port gasket.

Rinse the ejector with warm water.

Cleaning

39THOMAS CAT&DOG XT THOMAS CAT&DOG XT