Ardo CB 540 [32/96] Installation gb for the user
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Ardo CB 540 [32/96] Installation gb for the user

Ardo CB 540 [32/96] Installation gb for the user
32
- release the knob in this position and move
a burning match towards the burner; IT
MUST NOT IGNITE.
Time needed to excite the magnet during
ignition: 10 seconds approx.
Automatic tripping time, after flame has been
turned off: not more than 90 seconds for hob
burners; not more than 60 seconds for oven
and grill burners.
IMPORTANT
- Before doing any work inside the cooker,
disconnect the mains plug and shut the gas
tap.
- Never use matches to check the gas cir-
cuit for leaks. If a specific control device is
not available, foam or very soapy water can
be used.
- When re-closing the hob, check that the
electrical wires of the spark plugs (if
present) are not close to the injectors, so
that they cannot run across them.
HOW TO USE THE COOKER
VENTILATION
All gas cooking appliances produce heat and
moisture in the rooms where they are
installed. Take care to ensure that the kitchen
is well ventilated; keep the ventilation
openings unobstructed or install an extractor
hood with fan.
In case of intensive or prolonged use,
additional ventilation may be required; open
a window, or increase the extractor fan power.
IGNITING THE HOB BURNERS
- Press the knob and turn it anti-clockwise
until it reaches the
symbol on the control
panel (maximum flame position);
- at the same time, move a burning match
towards the burner head;
- to reduce the flame, turn the knob further
in the same direction until its pointer is
against the
symbol (minimum flame po-
sition).
FOR HOB BURNERS EQUIPPED WITH
SAFETY DEVICE
- Press the knob and turn it anti-clockwise
until it reaches the
symbol on the control
panel (maximum flame position);
- move a burning match towards the burner,
keeping the knob pressed right dow for
about 10 seconds;
- then release the knob and check that the
burner remains on. Otherwise, repeat the
operation.
IGNITING THE OVEN BURNER
- Open the oven door;
- press the knob and turn it anti-clockwise to
the maximum flame position;
- move a burning match towards the hole in
the centre of the oven bottom and press
the knob right down (see fig. 9);
- check that the burner has ignited, looking
through the hole in the centre of the bot-
tom, keeping the knob pressed all the time;
Installation
GB
For the user

Содержание

Похожие устройства

Скачать