SNR SR2212RS — настройка интерфейса IPMI: статический режим и Java SOL [187/195]

Превью страниц Страница 187 / 195

7.1.3

IPMI interface configuration Static mode

If you choose to configure Static mode for the IPMI interface, you should pay attention to the following

issues:

（1）

If there are multiple IPMI devices in your local area network, please note that the IP addresses

between the devices cannot be repeated, otherwise communication cannot be established.

（2）

If the IP of your IPMI device is an intranet address, the terminal device communicating with it

must be in the same network segment as the IPMI device address.

（3）

The IP address of the IPMI device can be mapped to the WAN through the routing device for

remote management.

（4）

The IPMI port has the function of obtaining an IP address through DHCP.

（5）

IPMI supports two protocols, TCP/IP v4 and TCP/IP v6.

Configure the IP address and subnet mask according to your actual situation. For example, here we set

the IP address to 192.168.0.236 and the subnet mask to 255.255.252.0, as shown in Figure 7-7 below. After

setting, press F4 to save and exit the BIOS interface.

Figure 7-7

7.1.4

IPMI configuration Java SOL

Press the <Del> key when the system starts to enter the BIOS setting interface.

Switch to the Advanced menu, select Serial Port Console Redirection, and press

<Enter> key.

Make sure that the Console Redirection of COM0 is in the [Enabled] state, if not, select Console

Redirection, and then press the <Enter> key to set the state to [Enabled]. To ensure the normal operation

of iBMC, this option has been set to [Enabled] by default.