AMERICAN DJ BOOM BOX FX3 [3/14] Dmx 512

ADJ Products, LLC - www.adj.com - Boom Box FX3 Instruction Manual Page 5ADJ Products, LLC - www.adj.com - Boom Box FX3 Instruction Manual Page 4

Safety Issues: This unit may “pop” the fuse if the maximum allotted

load of 2 amps is reached.

• To reduce the risk of electrical shock or re, do not expose this unit

rain or moisture.

• Do not spill water or other liquids into or on to your unit.

• Do not attempt to remove or break o the ground prong from the

electrical cord. This prong is used to reduce the risk of electrical

shock and re in case of an internal short. Do not attempt to oper-

• Do not attempt to operate this unit, if it becomes damaged.

• This unit is intended for indoor use only, use of this product out-

doors voids all warranties.

• During long periods of non-use, disconnect the unit’s main power.

• Always mount this unit in safe and stable matter.

• Power cords should be routed so they are not likely to be walked

on, pinched by items placed upon or against them.

• Cleaning -The fixture should be cleaned only as recommended by

the manufacturer. See page 23 for cleaning details.

• Heat -The appliance should be situated away from heat sources

D. The unit does not appear to operate normally or exhibits a

marked change in performance.

Boom Box FX3 Safety Precautions

Power Supply: The ADJ Boom Box FX3 contains a automatic volt-

age switch, which will auto sense the voltage when it is plugged into

the power source. With this switch there is no need to worry about the

correct power voltage, this unit can be plugged in anywhere.

DMX-512: DMX is short for Digital Multiplex. This is a universal pro-

tocol used by most lighting and controller manufactures as a form of

communication between intelligent fixtures and controllers. A DMX

gle controller, as long as all xtures and the controller are DMX com-

pliant. To ensure proper DMX data transmission, when using several

DMX fixtures try to use the shortest cable path possible. The order

in which fixtures are connected in a DMX line does not influence the

DMX addressing. For example; a fixture assigned a DMX address of 1

may be placed anywhere in a DMX line, at the beginning, at the end,

or anywhere in the middle. When a fixture is assigned a DMX address

of 1, the DMX controller knows to send DATA assigned to address 1

to that unit, no matter where it is located in the DMX chain.

Data Cable (DMX Cable) Requirements (For DMX and Master/Slave

DMX cables. If you are making your own cables, be

sure to use standard 110-120 Ohm shielded cable

(This cable may be purchased at almost all pro-

fessional sound and lighting stores). Your cables

should be made with a male and female XLR con-

nector on either end of the cable. Also remember

that DMX cable must be daisy chained and cannot

be split.

Boom Box FX3 DMX Set Up

Figure 1