Maxwell MW-1101 W [4/48] English

Maxwell MW-1101 W [4/48] English
4
ENGLISH
The unit is intended for household usage
only; usage for commercial purposes is
prohibited.
Preparation for operation
Unpack the unit.
Before you connect the unit to the mains,
make sure that the voltage specified on
the unit corresponds to the voltage in
your home socket.
Carefully wash all the removable parts,
which will contact with products, and dry
them.
Note: Be carefully while holding the
shredding sieve; its surface is very
sharp.
Wash vegetables/fruits and cut them into
pieces, which will easily pass into the
cover throat of the unit.
While extracting juice from stone fruits
(for instance cherry, peach etc.) remove
pits from the fruits.
Making juice
Put the unit on the stable dry and flat sur-
face.
Before assembling, make sure that the
unit is switched off and unplugged.
Set the juice tank (5) on the motor unit
(9).
Set the shredding sieve (4) in the juice
tank (5.
Note: - Do not use the shredding sieve
if it has any defects.
Set the cover (3) on the juice tank (5).
Set the juice container (8).
Put a container (11) under the pouring
spout (6).
Set the clamps (7) vertically, fixing the lid
(3).
Insert the plug into the socket.
Switch on the juicer by setting the switch
(10) to the “1/low speed” position or to
the “2/high speed’ position.
Use the “*/Pulse” mode for short-time
operation of the juicer at the maximal
speed.
Note:
- “1/low speed” - is used to extract
juice from soft vegetables/fruits (to-
matoes, pears, strawberry, oranges,
plums, grapes, pumpkin, onion, cu-
cumbers etc.).
- “2/high speed” - is used to extract
juice from hard vegetables/fruits
(artichoke, carrot, apples, pepper,
beetroot, potatoes, pineapples, veg-
etable marrows, celery, spinage, dill,
kurrat etc.).
- “*/Pulse” is the analogue to the “2/
high speed” mode, but the operating
modes switch is not fixed.
- the unit will switch on only if all the re-
movable parts are installed properly
and the upper cover is fixed by the
clamps (7).
Put the products only while the motor is
operating.
Gradually put preliminary cut pieces of
the products into the throat (2) of the
cover (3) and slightly press them with
the pusher (1). Do not press strongly the
pusher; it can lead to worse quality of the
juice or to a stop of the shredding sieve
rotation (4).
Do not immerse your fingers or other ob-
jects into the throat (2) of the cover (3).
Periodically check the condition of the
shredding sieve (4) concerning blockage
of the filter, if necessary wash the shred-
ding sieve (4).
Check the container (8), if it is full, switch
off the unit, take the plug out of the sock-
et, remove the container (8) and remove
the pressed skins.
Check the juice tank (11); periodically
pour out the juice from it.
MW-1101.indd 4MW-1101.indd 4 27.05.2009 9:40:4827.05.2009 9:40:48

Содержание

Похожие устройства

Скачать