AMERICAN DJ Starburst [9/10] Starburst notes
![AMERICAN DJ Starburst [9/10] Starburst notes](/views2/2008150/page9/bg9.png)
ADJ Products, LLC - www.adj.com - Starburst Instruction Manual Page 16
Starburst Warranty
MANUFACTURER’S LIMITED WARRANTY
A. ADJ Products, LLC hereby warrants, to the original purchaser, ADJ Products, LLC products
to be free of manufacturing defects in material and workmanship for a prescribed period from
the date of purchase (see specific warranty period on reverse). This warranty shall be valid only if the
product is purchased within the United States of America, including possessions and
territories. It is the owner’s responsibility to establish the date and place of purchase by acceptable
evidence, at the time service is sought.
B. For warranty service you must obtain a Return Authorization number (RA#)
before sending back the product–please contact ADJ Products, LLC Service Department
at 800-322-6337. Send the product only to the ADJ Products, LLC factory. All
shipping charges must be pre-paid. If the requested repairs or service (including
parts replacement) are within the terms of this warranty, ADJ Products, LLC will pay return
shipping charges only to a designated point within the United States. If the entire instrument is
sent, it must be shipped in it’s original package. No accessories should be shipped with the product. If
any accessories are shipped with the product, ADJ Products, LLC shall have no liability whatsoever for
loss of or damage to any such accessories, nor for the safe return thereof.
C. This warranty is void if the serial number has been altered or removed; if the product is modified in any
manner which ADJ Products, LLC concludes, after inspection, affects the reliability of the product; if the
product has been repaired or serviced by anyone other than the ADJ Products, LLC factory unless prior
written authorization was issued to purchaser by ADJ Products, LLC; if the product is damaged because
not properly maintained as set forth in the instruction manual.
D. This is not a service contract, and this warranty does not include maintnance, cleaning or periodic check
up. During the period specified above, ADJ Products, LLC will replace defective parts at its expense
with new or refurbished parts, and will absorb all expenses for warranty service and repair labor by
reason of defects in material or workmanship. The sole responsibility of ADJ Products, LLC under this
warranty shall be limited to the repair of the product, or replacement thereof, including parts, at the sole
discretion of ADJ Products, LLC. All products covered by this warranty were manufactured after August
15, 2012, and bear indentifying marks to that effect.
E. ADJ Products, LLC reserves the right to make changes in design and/or improvements upon its products
without any obligation to include these changes in any products theretofore manufactured.
No warranty, whether expressed or implied, is given or made with respect to any accessory supplied with
products described above. Except to the extent prohibited by applicable law, all implied warranties made
by ADJ Products, LLC in connection with this product, including warranties of merchantability or fitness,
are limited in duration to the warranty period set forth above. And no warranties, whether expressed or
implied, including warranties of merchantability or fitness, shall apply to this product after said period
has expired. The consumer’s and/or Dealer’s sole remedy shall be such repair or replacement as is
expressly provided above; and under no circumstances shall ADJ Products, LLC be liable for any loss or
damage, direct or consequential, arising out of the use of, or inability to use, this product.
This warranty is the only written warranty applicable to ADJ Products, LLC Products and
supersedes all prior warranties and written descriptions of warranty terms and conditions heretofore
published.
MANUFACTURER’S LIMITED WARRANTY PERIODS:
•LightingProducts=1-year(365days)LimitedWarranty(Such as: Special Effect Lighting, Intelligent
Lighting, UV lighting, Strobes, Fog Machines, Bubble Machines, Mirror Balls, Par Cans, Trussing,
Lighting Stands etc. excluding LED and lamps)
•LaserProducts=1Year(365Days)LimitedWarranty(excluding laser diodes which have a 6 month
limited warranty)
•L.E.D.Products=2-year(730days)LimitedWarranty(excluding motors, PCB boards, and power
supplies, which have a 1-year (365 day Limited Warranty) batteries which have a 180 day limited war-
ranty). Only the L.E.D.s carry a 2-year warranty (excludingStarTecSerieswhichacarriesa1Year
Limited Warranty)
•ADJDMXControllers=2Year(730Days)LimitedWarranty(excluding faders and tact switches)
ADJ Products, LLC - www.adj.com - Starburst Instruction Manual Page 17
Starburst Notes
Содержание
- Starburst 1
- User instructions 1
- Caution 2
- Customer support 2
- Introduction 2
- To purchase parts online visit http parts americandj com 2
- Unpacking 2
- Warning 2
- Dmx 512 3
- Power supply 3
- Be sure to follow figures two and three when making your own cables do not use the ground lug on the xlr connector do not con nect the cable s shield conductor to the ground lug or allow the shield conductor to come in contact with the xlr s outer casing grounding the shield could cause a short circuit and erratic behavior 4
- Conductor 5 pin xlr male in 3 pin xlr female out 4
- Data compliment signal 4
- Data true signal 4
- Dmx cable must be daisy chained and cannot be split cable 4
- Ground shield 4
- Not used 4
- Notice 4
- Pin 4 do not use 4
- Pin 5 do not use 4
- Pin xlr dmx connectors 4
- Pin xlr to 5 pin xlr conversion 4
- Some manufactures use 5 pin dmx 512 data cables for data transmission in place of 3 pin 5 pin dmx fixtures may be implemented in a 3 pin dmx line when inserting stan dard 5 pin data cables in to a 3 pin line a cable adaptor must be used these adaptors are readily available at most electric stores the chart below details a proper cable conversion 4
- Special note line termination 4
- Starburst set up 4
- When longer runs of cable are used you may need to use a terminator on the last unit to avoid erratic behavior a terminator is a 110 120 ohm 1 4 watt resistor which is con nected between pins 2 and 3 of a male xlr connector data and data this unit is inserted in the female xlr connector of the last unit in your daisy chain to terminate the line using a cable terminator adj part number z dmx t will decrease the possibilities of erratic behavior 4
- Channel value function 7
- Master slave operation 7
- On the slave units 7
- Red 0 255 0 100 2 green 0 255 0 100 3 blue 0 255 0 100 4 white 0 255 0 100 5 yellow 0 255 0 100 6 purple 0 255 0 100 7 strobing 0 7 off 8 15 led on 16 131 strobing slow fast 132 139 led on 140 181 slow open fast close 182 189 led on 190 231 fast open slow close 232 239 led on 240 247 random strobe 248 255 led on 8 master dimmer 0 255 0 100 9 rotation 0 30 no rotation 31 140 clockwise rotation fast slow 141 145 stop 146 255 counter clowise rotation slow fast 10 color macros 0 25 no function 26 205 color macros 7
- Universal dmx control 7
- Channel value function 8
- Color macros 206 255 color changing fast slow 11 pan color macros 0 55 no function 56 75 sound active 76 105 red clockwise rotation 106 135 blue counter clockwise 136 165 7 color change clockwise 166 195 7 color change counter clockwise rotation 196 225 7 color change with strobe clockwise rotation 226 255 7 color change with strobe counter clockwise rotation 12 reset 0 69 no function 70 85 reset 86 255 no function 8
- Fixture cleaning 8
- Adj products llc www adj com starburst instruction manual page 16 9
- Adj products llc www adj com starburst instruction manual page 17 9
- Starburst notes 9
- Starburst warranty 9
- A d j supply europe b v junostraat 2 6468 ew kerkrade netherlands service adjgroup eu www adj eu tel 31 45 546 85 00 fax 31 45 546 85 99 10
- Adj products llc 6122 s eastern ave los angeles ca 90040 usa tel 323 582 2650 fax 323 725 6100 web www adj com e mail info americandj com 10
- Auto sensing voltage 10
- Model starburst 10
- Please note 10
- Specifications and improvements in the design of this unit and this manual are subject to change without any prior written notice 10
- This fixture contains a automatic volt age switch which will auto sense the voltage when it is plugged into the power source 10
Похожие устройства
- AMERICAN DJ Rotobeam 4 Руководство по эксплуатации
- AMERICAN DJ Reflex Pulse LED Руководство по эксплуатации
- AMERICAN DJ Penta Pix Руководство по эксплуатации
- Dynacord PowerSub 312 230 В Руководство по эксплуатации
- Dynacord PSD 215 Руководство по эксплуатации
- AMERICAN DJ Scene Setter 24 Руководство по эксплуатации
- Dynacord PowerMate 1000-3 Руководство по эксплуатации
- Dynacord D-LITE 1000 Руководство по эксплуатации
- Dynacord D 12 Руководство по эксплуатации
- Dynacord COBRA-PWH Руководство по эксплуатации
- Dynacord C 15.2 Руководство по эксплуатации
- Dynacord COBRA-4 FAR Руководство по эксплуатации
- Dynacord A 115A Руководство по эксплуатации
- Dynacord A 118 Руководство по эксплуатации
- Dynacord A 112 Руководство по эксплуатации
- DIALIGHTING WASH ZOOM 19x40 IP67 Руководство по эксплуатации
- DIALIGHTING SUPER MINI Wash 6-15 Руководство по эксплуатации
- DIALIGHTING Spot Led 400 CMY Руководство по эксплуатации
- DIALIGHTING SUPER MINI SPOT 75 Руководство по эксплуатации
- DIALIGHTING MINI SPOT 100 Руководство по эксплуатации