Infiniti G37 Convertible (2010) [355/444] 10 15 09 tbrook

Infiniti G37 Convertible (2010) [355/444] 10 15 09 tbrook
5. Remove the protective cap
A
of the hose
and screw the hose securely onto the tire
valve. Make sure that the pressure re-
lease valve
B
is securely tightened.
Make sure that the air compressor switch
is in the OFF () position, and then insert
its power plug into the power outlet in the
vehicle.
6. Push the ignition switch to the “ACC”
position. Then turn the compressor switch
to the ON () position and inflate the tire
up to the pressure that is specified on the
tire and loading information label affixed
to the driver’s side center pillar if pos-
sible, or to the minimum of 180 kPa (26
psi). Turn the air compressor off briefly in
order to check the tire pressure with the
pressure gauge.
If the tire is inflated to higher than the
specified pressure, lower the tire pressure
by releasing air with the pressure release
valve.
NOTE:
The compressor tire pressure gauge may
show a pressure reading of 87 psi (600 kPa)
for about 30 seconds while inflating the
tire. The pressure gauge is indicating the
pressure inside the sealant can. When the
sealant has been injected into the tire the
pressure gauge will drop and indicate ac-
tual tire pressure.
WARNING
To avoid serious personal injury while using
the emergency tire puncture repair kit:
Securely tighten the compressor hose to
the tire valve. Failure to do so can cause
the sealant to spray into the air and get
into your eyes or on the skin.
Do not stand directly beside the damaged
tire while it is being inflated because of the
risk of the rupture. If there are any cracks or
bumps, turn the compressor off
immediately.
If the tire pressure does not increase to 180
kPa (26 psi) within 10 minutes , the tire may
be seriously damaged and the tire cannot
be repaired with this tire repair kit. Contact
an INFINITI retailer.
SCE0870 SCE0871
6-10 In case of emergency
10/15/09—tbrooks

Содержание

Похожие устройства

Скачать