Lexicon PCM96 SUR-D [34/64] System menu

systeM MenU

The System Menu lets you adjust several settings in the PCM96 Surround.

To access the System Menu, press the Select knob while a System Preset is

loaded.

The System Menu contains sub-menus and options. Sub-menus contain

options and/or more sub-menus. To enter a sub-menu, highlight it with the

Select knob and press the Select knob. Options contain values that you can

adjust (indicated by a colon followed by a value, for example, “Audio Source:

ANALOG”). To adjust an option’s value, turn the corresponding knob:

Knob A for an option on the first line, Knob B for an option on the second

line, and Knob C for an option on the third line. Press the Back button at

any time to save your changes and move one level up through the menus

and sub-menus.

aUdio setUP

The Audio Setup sub-menu contains the following options:

Audio Source

This is a global setting that configures the PCM96 Surround to accept

ANALOG or AES input.

Clock Source

Select your clock source here. Choose from INTERNAL, AES, and BNC.

Clock Rate

Select your clock rate here, when the wordclock source is set to

INTERNAL. Choose from 44.1HKz, 48KHz, 88.2KHz, or 96KHz.

Analog Setup

The Analog Setup sub-menu lets you adjust the following parameters:

Analog Input Level - Increases or decreases the incoming analog signal

before it reaches the processor(s). Set to +4dBU or –10dBU.

Analog Output Level - Increases or decreases the outgoing analog signal

after it leaves the processor(s). Set to +4dBU or –10dBU.

Global Mute - Mutes all signals from the PCM96 Surround. Set to

Muted or Unmuted.

AES Setup

The AES Setup sub-menu gives you the status of the following AES infor-

mation:

Data Validity - “Valid” indicates the data is OK. “Invalid” indicates that

the Validity bit was set in a frame of incoming data and that the data

attached to it may be corrupted. This bit may also be sent when the

transmitting device is paused.

Mode - Select “Consumer” to send information in S/PDIF format.

Select “Professional” to send information in AES format.