KRAFT Technology TCH-HD8586SW [42/76] Automatic washing machine

KRAFT Technology TCH-HD8586SW [42/76] Automatic washing machine
42
USER GUIDE
AUTOMATIC WASHING MACHINE
Malfunction Troubleshooting method
Washing machine doesn't turn on.
Connect the machine to the mains. Press the "On/Off" button, then the
"Start/Pause" button. Spread out the water supply hose.
Washing machine does not work.
Open the tap until it stops. Clean the filter on the water supply hose. Close
the washing machine door.
The loading hatch does not open
after washing.
The hatch lock locking system is enabled. Disconnect the washing
machine from the power supply.
The water does not heat up.
Make sure that the cold-water wash mode is not selected.
The heating element is damaged. Contact the service center.
Water under the washing machine. Check the connection of the water supply hose.
The indicators are not highlighted.
Power supply is disrupted. Check the power connection.
The control board is damaged. Contact the service center.
Bad / weak spin.
Dose detergent according to the degree of soiling and water hardness
(see recommendations on the detergent pack). Clean the pump filter.
The washing machine does not
spin.
Remove and re-load the items into the drum, clean the pump.
Washing machine does not collect
water.
1. Open the pump filter.
2. Check the water pressure.
3. Reconnect the water supply hose.
4. Close the washing machine door.
5. Check and make sure that the hose is not twisted or pinched.
Washing machine draws and drains
water at the same time.
Check and make sure that the end of the drain hose is located above 100-
125 cm from the floor level.
The door lock is faulty.
Check that the clothes are not stuck between the drum and the door.
Remove the interference. Close the door tightly. Contact the service
center if necessary.
The heating element is faulty.
Close the water tap, disconnect the machine from electricity and water
supply. Contact the service center.
Water overflows.
The drum does not rotate.
Vibration in the washing machine.
Check and make sure that all the transport bolts are removed.
Adjust the position of the washing machine level in different planes.
There is a large amount of foam
through the compartments for
washing powder.
Reduce the dose of detergent.
Check the water hardness, as well as the amount and type of detergent
used.
Interrupting the washing process
until the end of the program.
Check the supply voltage, water supply, and water drain.
Check the supply voltage, water
supply, and water drain.
The washing machine is equipped with an automatic water top-up system.
The suspension is caused by the removal of excess foam.
ATTENTION! Troubleshooting that is not spelled out in this manual can only
be carried out by a qualied specialist.

Содержание

Похожие устройства