Karcher HDS 1195-4 S Eco [33/484] Appliance is not running

Karcher HDS 1195-4 S Eco [33/484] Appliance is not running
– 10
Fuel tank empty
Refill.
Engine overload/overheat
Turn device switch on "0" and let engine
cool off for min. 5 minutes.
If malfunction still occurs, have device
checked by customer service.
No line voltage, see "Appliance is not
running".
Liquid softener tank is empty, due to
technical reasons a remainder stays in
the tank.
Refill.
Electrodes in the tank are dirty
Clean the electrodes.
Set the appliance switch to "0".
Allow device to cool down.
Set the appliance switch to "I".
No power
Check power connection/conduit.
Air within the system
Vent pump:
Set dosing value for detergent to "0".
With open hand spray gun turn device
on and off multiple times with the device
switch.
Close and open the regulating spingle
(figure 9) with open hand spray gun.
Note: By dismantling the high pressure
hose from the high pressure connection the
venting process is accelerated.
If detergent tank is empty, refill.
Check connections and conduits.
Pressure is set to MIN
Set pressure to MAX.
Sieve in the water connection is dirty
Clean sieve.
Clean the fine filter; replace it, if neces-
sary.
Amount of water supply is too low.
Check water supply level (refer to tech-
nical data).
Pump leaky
Note: 3 drops/minute are allowed.
With stronger leak, have device
checked by customer service.
Leak in the high pressure system
Check high pressure system and con-
nections for tightness.
Leave device running with open deter-
gent dosage valve and closed water
supply, until the swimmer tank is
sucked empty and the pressure falls to
"0".
Open the water supply again.
If the pump still is not sucking in any deter-
gent, it could be because of the following
reasons:
Filter in the detergent suck hose dirty
Clean filter.
Backflow valve stuck
Figure 15
Remove the detergent hose and loosen
the backflow valve using a blunt object.
Fuel tank empty
Refill.
Water shortage
Check water supply, check connec-
tions, clean water shortage safeguard.
Fuel filter dirty
Change fuel filter.
Fuel indicator lamp glows
Indicator lamp "Ready for use"
turns off
Indicator lamp liquid softener glows
Engine control lamp glows
Appliance is not running
Device is not building up pressure
Device leaks, water drips from the
bottom of the device
Device turns on and off while hand
spray gun is closed
Device is not sucking in detergent
Burner does not start
33EN

Содержание

Скачать