![Tc Electronic TRIPLE-C STEREO [24/31] Using compression](/img/pdf.png)
Tc Electronic TRIPLE-C STEREO [24/31] Using compression
![Tc Electronic TRIPLE-C STEREO [24/31] Using compression](/views2/1011842/page24/bg18.png)
24
USING COMPRESSION
Though you can say that using a Compressor in general is
about reducing the dynamic content of a signal thereby
having better control, there are many different angles on
how to use compression. Depending on the specific
application you may have different starting points and goals
when you apply compression. As personal style also is a
major consideration it is hard to give specific answers on
how to use compression. However, here are some guide-
lines.
First a short description of the basic parameters.
Illustration
Dynamic Section
Threshold
When the signal rises above the set Threshold point the
Compressor is activated.
Ratio
The Ratio setting determines how hard the signal is
compressed.
Attack
The Attack time is the response time of the Compressor.
The shorter Attack time the sooner the Compressor will
start to work after the signal rises above the set Threshold.
Release
The Release time is the time it takes for the Compressor to
release the gain reduction of the signal after the signal
drops below the Threshold point again.
Example:
Threshold is set to -6dB
Ratio is set to 2:1
Attack is set to 10ms
Release is set to 300ms
A relatively loud musical phrase reaches -2dB on the Input.
As the Threshold is set to -6dB, 4dB of the signal will be
processed. The Ratio of 2:1 means that each of the 4dBs
above Threshold will be reduced to 0.5dB. So, the 4dB above
Threshold on the Input side will be reduced to only 2dB on
the Output. This gain-reduction is reached in 10ms which is
specified by the Attack time. When the Input signal drops
below the Threshold (-6dB) again, the Compressor ceases
to process/reduce the Output signal. The Release time
specifies how long it will take until no processing is taking
place.
Spectral Adjust Section
Selecting Full-range or Multi-band mode
Evaluate the frequency range of the source material. If your
source material has a wide frequency range with peaks in
specific frequency areas, the Multi-band mode should
probably be your choice. If on the other hand you are
working on e.g a repeating back-up vocal harmony within a
relatively small frequency area the Full range mode would
apply perfectly.
Better Definition of Vocal material
If the object is to define the Source material e.g a voice a
gentle compression would be appropriate. By delicately
controlling the peaks of the signal you are able increase
the overall level of the signal and the low level content of
the signal will be increased. Try using a high Threshold
setting to keep the dynamic content of the signal and to
avoid processing the entire signal all the time. A low to
medium Ratio and Attack setting will give you the soft and
often desired compression used when working with vocals.
Guideline Settings
Ratio: 2:1
Attack: 10ms
Release: 200ms
Содержание
- Triple c 1
- User s manual 1
- Appendix 3
- Basic operation 3
- Compression modes 3
- Introduction 3
- Table of contents 3
- Introduction 5
- Front panel 6
- Front panel 7
- Rear panel 8
- Signal flow 9
- Setting up the triple c 10
- Triple c setups 10
- Setting up the triple c 11
- Triple c setups 11
- The triple c display 12
- I o setup 13
- I o setup 14
- Recall 15
- Recall edit store 15
- Dynamic section 16
- Full range mode 16
- Input section 16
- Makeup gain section 16
- Edit menu 17
- Full range mode 17
- Dynamic section 18
- Input section 18
- Multi band mode 18
- Spectral adjust 18
- Edit menu 19
- Makeup gain 19
- Meters 19
- Multi band mode 19
- Dynamic section 20
- Envelope mode 20
- Input section 20
- Edit menu 21
- Envelope mode 21
- Makeup gain 21
- External eq 22
- Sidechain operation 22
- Stereo link 22
- Using compression introduction 23
- Dynamic section 24
- Spectral adjust section 24
- Using compression 24
- Using compression 25
- Important safety instructions 26
- Warning 26
- Important safety instructions 27
- Appendix midi implementation chart 28
- Appendix midi control changes 29
- Appendix technical specifications 30
- Technical specifications are subject to change without notice 30
- Preset list 31
Похожие устройства
- Pandora RX-100 (2006 г) Инструкция по эксплуатации
- Hertz Hertz HE 1D Инструкция по эксплуатации
- Casio EX-ZS10 Black Инструкция по эксплуатации
- Viking МВ-443.0 Х 63360113490 Инструкция по эксплуатации
- Toshiba SD-42HKSB Инструкция по эксплуатации
- Pandora RX-112 Инструкция по эксплуатации
- Hertz SX 250D Инструкция по эксплуатации
- Tc Electronic C300 Инструкция по эксплуатации
- Casio EX-ZS10 Red Инструкция по эксплуатации
- Bosch TWK 6008 Инструкция по эксплуатации
- Mega 5200 HHT Инструкция по эксплуатации
- Tc Electronic D-TWO Инструкция по эксплуатации
- Hertz SX 300D Инструкция по эксплуатации
- Pandora RX-117 Инструкция по эксплуатации
- Casio EX-H30 Silver Инструкция по эксплуатации
- Bosch TWK 6004 Инструкция по эксплуатации
- Mega 4720 RTT Инструкция по эксплуатации
- Tc Electronic M-ONE XL Инструкция по эксплуатации
- Sony HT-SL55 Инструкция по эксплуатации
- Pandora RX-121 Инструкция по эксплуатации