Kramer Aspen RCP-1616 [45/52] Power saving mode

ASPEN 1616 AND 3232 RCP CONTROL PANELS

Power Saving Mode

 Press and hold the FUNC until it turns BLUE.

 Press and release the Salvo button while holding the FUNC button.

The LOCK button will indicate the power saving mode.

 Blue if Enabled

 Off if Disabled

Toggle the LOCK button to enable and disable.

Error Indications

Not Connected to a routing switcher

There are several reasons why the RCP cannot connect to the routing switcher. In any of

these situations the RCP will enter the “scrolling LED” state. The unit will turn on an LED

in each Input button one at a time then each Output button one at a time. Once it reaches

the last Output button, it will start again at the beginning. The RCP will use different

colors to indicate the different error situations.

Note that while in this state the user can press and hold the FUNC button to get to the

Setup functionality. When this happens, the “scrolling” will stop. When the user releases

the FUNC button, the “scrolling” will restart.

No network

If the RCP does not detect the network connection, the LEDs will cycle in RED.

No IP Address

If the RCP does not have a valid IP address, the LEDs will cycle in PURPLE. There are

two ways this can happen:

1. The panel is configured for DHCP and it has not received an IP address from the

DHCP server.

2. The user has put in a bad IP Address for this panel and/or this field has become

corrupt within the configuration.

Missing Routing Switcher

If the RCP detects all of the network settings are correct and it still cannot connect to the

routing switcher, the LEDs will cycle in GREEN.

RCP Configuration Fault

If there is a serious problem with the RCP where it cannot operate properly, the LOCK

and FUNC buttons will blink RED. All other buttons on the panel will be off.