Trendnet TEG-2248WS [26/46] Configuring the switch

Configuring the Switch

The 48+4G-Port 10/100/1000Mbps Gigabit Ethernet Web Smart

Switch has a Web GUI interface for smart switch configuration. The

Switch can be configured through the Web Browser. A network

administrator can manage, control and monitor the switch from the

local LAN. This section indicates how to configure the Switch to

enable its smart functions including:

 Port Setting (Speed/Disable, Duplex mode, Flow Control and

Port base QoS)

 Virtual LAN Group setting (VLAN)

 Trunking

 System Setting

 Device status and Statistic

Before you configure this device, note that when the Web Smart

Switch is configured through an Ethernet connection, make sure the

manager PC must be set on same the IP network. For example, when

the default network address of the default IP address of the Web Smart

Switch is 192.168.0.1, then the manager PC should be set at

192.168.0.x (where x is a number between 2 and 254), and the default

subnet mask is 255.255.255.0.