Smeg STO905 [7/35] Installation instructions

2.1 Water supply connection

Preventing the risk of clogging or damage: the water pipe is new or has not

been used for a long time, before connecting to the water supply check that

the water is clear and free of impurities, to prevent damage to the appliance.

The dishwasher must always be connected to the water system with new

hoses; old or used hoses must never be reused.

CONNECTING TO THE WATER SUPPLY

Connect the intake hose to a cold water supply with ” gas

thread, inserting the  lter A supplied with the dishwasher.

Take care to screw the hose  rmly into place with your

hands and then complete by tightening about 1/4 of a

turn with pliers.

In dishwashers equipped with the ACQUASTOP device,

the  lters is already  tted inside the threaded ring.

DRAIN CONNECTION

Fit the drain hose into a pipe having diameter of at least 4 cm; the dishwasher

is  tted with a special device which allows column installation, even with the

drain pipe below the level of the dishwasher.

2.2 Electrical connection and precautions

CHECK THAT THE VOLTAGE AND THE FREQUENCY OF THE MAINS MATCH

THE RATINGS ON THE NAME PLATE OF THE APPLIANCE POSITIONED ON THE

INNER EDGE OF THE DOOR.

THE PLUG ON THE SUPPLY CORD AND THE CORRESPONDING SOCKET

OUTLET MUST BE OF THE SAME TYPE AND MEET THE REGULATIONS IN

FORCE.

THE PLUG MUST BE ACCESSIBLE AFTER INSTALLATION.

NEVER DISCONNECT THE PLUG BY PULLING ON THE POWER SUPPLY

LEAD.

IN THE EVENT OF DAMAGE TO THE SUPPLY CORD, HAVE IT REPLACED BY

THE MANUFACTURER OR AN AUTHORIZED TECHNICAL SERVICE CENTRE.

DO NOT USE ADAPTORS OR SHUNT CONNECTIONS IN ORDER TO AVOID THE

POSSIBILITY OF OVERHEATING OR BURNING.

Installation Instructions