Moxa MPC-2247X [54/64] Connecting to the uart control interface

MPC-2240 Hardware Manual Display Control Interface

6-2

Connecting to the UART Control Interface

The control interface of the MPC-2240 is accessed over the COM3 serial port. A Telnet terminal (like Moxa’s

Moxa’s PComm terminal emulator, or PuTTY) should be used to communicate with the display.

When launching a terminal emulator you will need to configure the connection. Below, we show you how to

configure an emulator using Moxa’s PComm terminal emulator. The relevant connection settings are shown in

steps 2 and

1. Select Port Manager, and then select Open.

2. Connection settings are shown below. When finished, click OK.

Protocol: Serial

Serial Parameters: COM3

Baud rate: 9600

Data bits: 8

Parity: None

Stop bits: 1

RTS state: ON

DTR state: ON

3. After successfully connecting, select Send pattern tab.