Moxa MPC-2260X [30/71] Connecting to the network

MPC-2000 Series Hardware Hardware Installation and Connection

3-12

(Storage)

The storage icon blinks red when data is been accessed on the MPC-2000 series.

NOTE

You can also control the MPC

-2000 series using commands over the UART interface. For detailed UART

command description,

see Appendix B: UART Commands for Display Control.

Connecting Data Transmission Cables

This section describes how to connect the MPC-2000 series to serial devices and the network.

Connecting to the Network

To connect the MPC-2000 series to a network, connect an Ethernet cable to an Ethernet port on the bottom

panel of the MPC-2000 series. The LED on the Ethernet port on the MPC-2000 series turns on to indicate that

an Ethernet connection has been established.

The following figures indicate the location of the Gigabit Ethernet ports.

MPC-2240/MPC-2260

MPC-2190

The 10/100/1000 Mbps Ethernet LAN port uses 8-pin RJ45 connectors. The following diagram shows the

pinouts and the descriptions for these ports.

Green 100 Mbps Ethernet mode

Yellow 1000 Mbps (Gigabit) Ethernet mode

Off No activity or 10 Mbps Ethernet mode

Pin 100 Mbps 1000 Mbps

1 ETx+ TRD(0)+

2 ETx- TRD(0)-

3 ERx+ TRD(1)+

4 – TRD(2)+

5 – TRD(2)-

6 ERx- TRD(1)-

7 – TRD(3)+

8 – TRD(3)-