Moxa OnCell 5104-HSPA-T [17/67] Attention

Moxa OnCell 5104-HSPA-T [17/67] Attention
OnCell 5000 Series Initial IP Address Configuration
3-3
ARP
You may use the ARP (Address Resolution Protocol) command to set up an IP address for your OnCell
5004/5104-HSPA. The ARP command tells your computer to associate the OnCell 5004/5104-HSPA’s MAC
address with an IP address. Afterwards, use Telnet to access the OnCell 5004/5104-HSPA and its IP address
will be reconfigured.
ATTENTION
In order to use the ARP setup method, both your computer and the OnCell
5004/5104-
HSPA must be connected
to the same LAN. You may use an Ethernet cable to connect the OnCell
5004/5104-HSPA directly to your
computer’
s Ethernet card. Before executing the ARP command, your OnCell 5004/5104-HSPA must be
configured with the factory default IP address (192.168.127.254) and your computer and the OnCell
5004
/5104-HSPA must be on the same subnet.
To use ARP to configure the IP address, complete the following:
1. Obtain a valid IP address for your OnCell 5004/5104-HSPA from your network administrator.
2. Obtain your OnCell 5004/5104-HSPA’s MAC address from the label on the bottom panel.
3. Execute the arp -s command from your computer’s MS-DOS prompt as follows:
arp -s <IP address> <MAC address>
For example,
C:\> arp -s 192.168.200.100 00-90-E8-04-00-11
4. Next, execute a special Telnet command by entering the following, exactly as written here:
telnet 192.168.200.100 6000
When you enter this command, a Connect failed message will appear, as shown below.
5. After the OnCell 5004/5104-HSPA reboots, its IP address will be assigned to the new address and you can
reconnect using Telnet to verify that the update was successful.
Telnet Console
Depending on how your computer and network are configured, you may find it convenient to use network
access to set up your OnCell 5000’s IP address. This can be done using Telnet.
ATTENTION
Figures in this section were taken from the
OnCell 5000 Telnet console.

Содержание

Похожие устройства

Скачать