Moxa OnCell 5104-HSPA-T [28/67] Guaranlink settings

OnCell 5000 Series Web Console Configuration

4-6

WAN Preference (default=Cellular): Select either cellular or Ethernet. Note that the WAN preference option

on the Ethernet WAN settings page (see below) will be updated automatically.

Note: You need to select one of the two WAN preferences. If the line is disconnected, the router will not

automatically switch to the other WAN preference.

NAT service (default=Enable): If you Enable NAT service, LAN-side applications will be able to link to

WAN-side applications.

Used SIM: Select the SIM card number that has been used, and please ensure inserting SIM card into right

slot.

The following information is only show SIM 1 configuration, If SIM 2 available, please follow the same setting

as well

SIM1 PIN: This is a pin code that locks the SIM card until you enter the correct code. Use the pin to protect

your account. The default code is set by the Service Provider. Note that a cell phone must be used to change

the PIN.

Band (default=Auto): The GSM/GPRS/EDGE/UMTS/HSPA band will be detected automatically.

SIM 1 PPP Config: This option allows the user to manually configure PPP authentication methods. Some

cellular providers may require users specify the dial-up number or PPP authentication method.

SIM 1 ATD: This is the number that the OnCell uses to dial onto the data network. Different countries may

require different dial-up numbers (default: *99***1#).

SIM 1 PPP Authentication: manually select PAP or CHAP authentication methods or use AUTO for auto

selection.

SIM 1 Username: This is the user ID account.

SIM 1 Password: This is the user password.

SIM 1 APN: Before using the GPRS, an APN (Access Point Name) must be configured as a modem initialization

command.

SIM 1 TCP/IP Compression: (default=Disable): Use this field to indicate whether the remote user’s

application requests compression.

SIM 1 Link Quality Report: (the default is set to “Disable”): Set this field to “Enable” for the following:

• Automatic disconnection if the link noise of the connection exceeds a user-defined threshold.

SIM 1 Connection Control: Configurable only when Ethernet is selected as WAN preference.

• Always ON/None: WAN connection will always stay connected.

• Remote Host Fail/Remote Host Recovered: WAN connection is only on when remote Host failed

to be reached by ping.

GuaranLink Settings

Overview

Connection failures of wireless connections can be caused by a number of different factors, including loss of

cellular signal, interferences or termination by the operator for unknown reasons. Typically, cellular routers will

not be alerted when a connection is terminated due to inactivity. And maintaining a stable cellular connection

is important for a number of obvious reasons. This is why OnCell cellular routers offer the GuaranLink function,

which ensures your wireless connection will be there whenever you need it.