Moxa VPort P06-1MP-M12-CAM42 [21/65] Client settings

VPort P06-1MP-M12 Accessing the VPort’s Web-based Manager

3-3

Client Settings

Users can configure the following functions in Client Settings.

1. Receiving Stream: Shows the encoding algorithm currently being used. The VPort P06-1MP-M12 features

2 built-in encode engines to generate a maximum of 3 simultaneous video streams. Each client can select

the H.264 video streams from Stream 1, or the MJPEG/ H,264 video stream from Stream 2. To configure

these video streams, please go to:

System Configuration/Video/Video Performance.

2. Media Options: Enable or disable the video or audio transmission.

3. Protocol Options: Choose one of four protocols to optimize your usage—Multicast (RTSP or Push) or

Unicast (UDP, TCP, HTTP).

• Multicast protocol can be used to send a single video stream to multiple clients. In this case, a lot of

bandwidth can be saved since only one video stream is transmitted over the network. However, the

network gateway (e.g., a switch) must support the multicast protocol (e.g., IGMP snooping). Otherwise,

the multicast video transmission will not be successful.

 RTSP: Enables the multicast video stream to be sent in RTSP control, which means the multicast video

stream will be sent only if it receives the client’s request.

 Push: Enables the multicast video stream to be sent in Push control, which means that after this setting

is selected the multicast video stream will be sent continuously even without any client request.

• Unicast protocol is used to send a single video stream to one client.

 UDP can be used to produce audio and video streams that are more real-time. However, some packets

may be lost due to network burst traffic, and images may become blurred.

 TCP can be used to prevent packet loss, which results in a more accurate video display. The downside

of using TCP is that the real-time delay is worse than with UDP protocol.

 HTTP can be used to prevent being blocked by a router’s firewall. The downside of using HTTP is that the

real-time delay is worse than with UDP protocol.

• Network Interface designates the connection interface for multicast video stream selection. The box lists

the current NIC interfaces. Select which NIC interface will receive multicast streams.

Once the IP camera is connected successfully, Protocol Options will indicate the selected protocol. The selected

protocol will be stored on the user’s PC, and will be used for the next connection.

NOTE

For multicast video stream settings, please refer to

System Configuration



Network



Multicast.