Scarlett SC-2167 [4/25] Important safeguards

IM013

www.scarlett.ru SC-2167

GB INSTRUCTION MANUAL

IMPORTANT SAFEGUARDS

• Please read this instruction manual carefully before use and keep in a safe place for future reference.

• Before the first connecting of the appliance check that voltage indicated on the rating label corresponds to the mains

voltage in your home.

• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental

capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning

use of the appliances by a person responsible for their safety.

• Children should be supervised to ensure that they do not play with the appliance.

• Do not use other attachments than those supplied.

• If the power cord is damaged it should be replaced by the manufacturer or authorized servicing center or qualified

professional for safety reasons.

• Do not attempt to repair, adjust or replace parts in the appliance. Check and repair the malfunctioning appliance in the

nearest service center only.

• Keep the cord away from sharp edges and hot surfaces.

• To avoid a circuit overload, do not operate another high wattage appliance on the same circuit.

• If the product has been exposed to temperatures below 0ºC for some time it should be kept at room temperature for at

least 2 hours before turning it on.

• The manufacturer reserves the right to introduce minor changes into the product design without prior notice, unless

such changes influence significantly the product safety, performance, and functions.

FLOOR INSTALLATION

• Turn over the convector, attach wheels to the bottom end of the appliance, make sure that the bolt holes are properly

aligned, then tighten the bolts (supplied).

• Place the convector on floor.

WALL INSTALLATION

• Press the "POWER" button on the control panel again, the appliance will start operating in high power mode.

TIMER SETTING

• Press the "TIMER" button located on the control panel.

• Press the "+" or "-" buttons to set the timer.

• The timer can be set within the range of 1 to 24 hours (with 1-hour increment). The timer will start operating 5 seconds

after the time is set.

• When the set time elapses, the convector will switch off.