Adaptec ASR-8405 SGL — как обновить прошивку с помощью командной строки AFU [102/117]

Updating the Flash Using the AFU Command Line

1. Create the rmware update disk (see Creating the Firmware Update Disk on page 98).

2. Shut down your operating system and reboot to DOS from a bootable DOS oppy disk or from a DOS

partition on a bootable drive. (You can use a disk connected to the controller you're updating.) If

your computer isn't set up to boot from the bootable oppy disk or a bootable device other than a

disk drive, enter the system setup utility to change the setting.

3. Insert the rmware update disk containing AFU.exe

4. At the DOS command, if you have multiple controllers and you don't know the number of the

controller you want to update, type AFU LIST, then press Enter. Otherwise, skip to the next step.

5. At the DOS command, type AFU followed by a command (see AFU Commands on page 99) and any

switches you want.

6. Update the ash using the instructions suitable for your requirements:

• To update a single RAID controller:

AFU UPDATE /C <cont_number>

Where <cont_number> is the number of the RAID controller whose rmware you are updating.

For example, to upgrade Controller 0, type AFU UPDATE /C 0

• To update multiple RAID controllers:

AFU UPDATE /C <cont_number_a>,<cont_number_b>

Where <controller_number_a> and <controller_number_b> are the numbers of the Adaptec RAID

controllers whose rmware you are updating. For example, to upgrade controllers 0, 2, and 3,

type AFU UPDATE /C 0, 2, 3

• To update all RAID controllers simultaneously:

AFU UPDATE /C all

Note: The UFI le identies the RAID controllers, so you don't have to worry

about ashing the wrong controller.

7. When prompted, insert the rmware disk.

The AFU processes the command and reports either success or an error message code.

102Proprietary and Condential to PMC-Sierra, Inc.

Document No.: CDP-00283-04-A Rev. A, Issue

Serial Attached SCSI RAID Controllers Installation and User's Guide