IKRA Mogatec BRM 1446 S [21/80] Gb operating instruction

IKRA Mogatec BRM 1446 S [21/80] Gb operating instruction
9
GB | Operating Instruction
4. Troubleshooting
PROBLEM PROBABLE CAUSE CORRECTIVE ACTION
Engine does not start
Throttle chock not in the correct po-
sition for the prevailing conditions.
Move throttle chock to correct
position.
Fuel tank is empty. Fill tank with fuel: refer to ENGINE
OWNERS MANUAL.
Air cleaner element is dirty. Clean air cleaner element: refer to
ENGINE OWNERS MANUAL.
Spark plug loose. Tighten spark plug to 25-30Nm.
Spark plug wire loose or discon-
nected from plug.
Install spark plug wire on spark
plug.
Spark plug gap is incorrect. Set gap between electrodes at 0.7
to 0.8mm.
Spark plug is defective Install new, correctly gapped
plug: refer to ENGINE OWNERS
MANUAL.
Carburetor is ooded with fuel. Remove air cleaner element and
pull starter rope continuously until
carburetor clears itself and install
air cleaner element.
Faulty ignition module. Contact the service agent.
Engine difcult to start or loses
power.
Dirt, water, or stale fuel tank. Drain fuel and clean tank. Fill tank
with clean, fresh fuel.
Vent hole in fuel tank cap is
plugged.
Clean or replace fuel tank cap.
Air cleaner element is dirty. Clean air cleaner element.
Engine operates erratically.
Spark plug is defective. Install new ,correctly gapped
plug: refer to ENGINE OWNERS
MANUAL.
Spark plug gap is incorrect. Set gap between electrodes at 0.7
to 0.8mm.
Air cleaner element is dirty. Clean air cleaner element: refer to
ENGINE OWNERS MANUAL.
Engine idles poorly.
Air cleaner element is dirty. Clean air cleaner element: refer to
ENGINE OWNERS MANUAL.
Air slots in engine shroud are
blocked.
Remove debris form shots.
Cooling ns and air passages under
engine blower housing are blocked.
Remove debris form cooling ns
and air passages.
Engine skips at high speed.
Gap between electrodes of spark
plug is too close.
Set gap between electrodes at 0.7
to 0.8mm.
Engine overheats
Cooling air ow is restricted Remover any debris from slots
in shroud, blower housing, air
passages.
Incorrect spark plug. I Install spark plug and cooling ns
on engine.
Mower vibrates abnormally
Cutting assembly is loose. Tighten blade.
Cutting assembly is unbalanced Balance blade.

Содержание

Скачать