Home
Главная
BEST
Вытяжка
Modular
Инструкция по эксплуатации Страница: 10

BEST Modular [10/40] English

English

KEY

LED

! The appliance must be installed by a qualified person

in compliance with the instructions provided.

Wear gloves when carrying out installation and

maintenance operations.

If the supply cord is damaged, it must be replaced by the

manufacturer, its service agent or similarly qualified

persons in order to avoid a hazard.

Only for hoods equipped with electronic control:

The 4th speed (intensive) is automatically lowered to 3rd

speed after 5 minutes of operation to optimise energy

consumption.

- If the hood is left on (lights and/or motor), after 10

hours in the absence of commands from the user, it will

automatically switch to OFF condition with all services

switched off.

- The Buzzer emits a “beep” each time that a command

is set from the keyboard or remote control (optional).

- In the event of interruption of power during the hood, if

you restore the hood in the OFF state, then the engine

must be reactivate manually.

AIR VENT

(for ducting versions)

! Prepare the hole and the air vent duct (150 mm

diameter).

! Use a duct of the minimum indispensible length.

! Use a duct with as few elbows as possible (maximum

elbow angle: 90°).

! Avoid drastic changes in the duct cross-section.

! Use a duct with an as smooth as possible inside.

! The duct must be made of certified material.

! Do not connect the hood to smoke exhaust ducts for

the products of combustion (boilers, fireplaces,

stoves, etc).

! For the air vents comply with the provisions laid down

by the competent authorities.

In addition, the air must not be evacuated through a

hole in the wall unless specifically intended for this

purpose.

! Fit air intakes in the room to prevent the hood from

creating a negative pressure in the room (which must

not exceed 0.04 mbar); if the hood is used at the same

time as non-electrical equipment (gas-, oil- and

charcoal-fired stoves, etc.) the exhaust gas may be

sucked in by the heat source.

FILTERING OR DUCTING VERSION ?

The hood may be in filtering or in ducting version.

Decide from the outset which type is to be installed.

For better efficiency, we recommend installing the hood

in the ducting version (if possible).

Ducting version

The hood purifies the air and evacuates it to the outside

through an exhaust duct (diameter 150 mm).

CONTROLS

Speed display

PU5: ON/OFF Motor 4

speed

PU4: ON/OFF Motor 3

speed

PU3: ON/OFF Motor 2

speed

PU2: ON/OFF Motor 1

speed

Filtering version

The hood purifies the air and recycles the clean air back

into the room. For this version, the following are

required: 1 air baffle, 1 reducer, 2 charcoal filters.

The upper flue air evacuation slots must be positioned

at the top.

CONTROLS

A) Turns the LIGHTS off

B) Turns the LIGHTS on.

C) Decreases speed down to minimum speed. If pressed for

2" the motor is turned off.

D) Activates the motor (calling the last speed used) and

increases the speed until reaching maximum.

E) FILTER ALARM/TIMER RESET: when pressing the key

during display of the filter alarm (motor off) it resets the hour

counter. When pressing the key when the motor is running, the

TIMER is activated and the hood will automatically be switched

off after 5 minutes.

L1) The 4 green LEDs indicate the running speed.

L2) When the LED is red (motor off) it indicates the FILTER

ALARM. When the LED is green (flashing) it indicates that the

TIMER has been activated with the key E.

- Filter alarm

After 30h of operation, the LED L2 turns RED. It indicates that

the grease filters need to be cleaned.

After 120h of operation, the LED L2 turns RED and flashes; It

indicates that the grease filters need to be cleaned and the

charcoal filters replaced.

After cleaning the grease filters (and/or replacing the charcoal

filters), restart the hour counter (RESET) by pressing the key

E during display of the filter alarm.

PU1: ON/OFF Lights

Содержание

Похожие устройства

English The appliance must be installed by a qualified person in compliance with the instructions provided A Wear gloves when carrying out installation and maintenance operations If the supply cord is damaged it must be replaced by the manufacturer its service agent or similarly qualified persons in order to avoid a hazard Only for hoods equipped with electronic control The 4th speed intensive is automatically lowered to 3rd speed after 5 minutes of operation to optimise energy consumption If the hood is left on lights and or motor after 10 hours in the absence of commands from the user it will automatically switch to OFF condition with all services switched off The Buzzer emits a beep each time that a command is set from the keyboard or remote control optional In the event of interruption of power during the hood if you restore the hood in the OFF state then the engine must be reactivate manually AIR VENT for ducting versions Prepare the hole and the air vent duct 150 mm diameter Use a duct of the minimum indispensible length Use a duct with as few elbows as possible maximum elbow angle 90 Avoid drastic changes in the duct cross section Use a duct with an as smooth as possible inside The duct must be made of certified material Do not connect the hood to smoke exhaust ducts for the products of combustion boilers fireplaces stoves etc For the air vents comply with the provisions laid down by the competent authorities In addition the air must not be evacuated through a hole in the wall unless specifically intended for this purpose Fit air intakes in the room to prevent the hood from creating a negative pressure in the room which must not exceed 0 04 mbar if the hood is used at the same time as non electrical equipment gas oil and charcoal fired stoves etc the exhaust gas may be sucked in by the heat source FILTERING OR DUCTING VERSION The hood may be in filtering or in ducting version Decide from the outset which type is to be installed For better efficiency we recommend installing the hood in the ducting version if possible version The hood purifies the air and recycles the clean air back into the room For this version the following are required 1 air baffle 1 reducer 2 charcoal filters The upper flue air evacuation slots must be positioned at the top CONTROLS I A Turns the LIGHTS off B Turns the LIGHTS on C Decreases speed down to minimum speed If pressed for 2 the motor is turned off D Activates the motor calling the last speed used and increases the speed until reaching maximum E FILTER ALARM TIMER RESET when pressing the key during display of the filter alarm motor off it resets the hour counter When pressing the key when the motor is running the TIMER is activated and the hood will automatically be switched off after 5 minutes L1 The 4 green LEDs indicate the running speed L2 When the LED is red motor off it indicates the FILTER ALARM When the LED is green flashing it indicates that the TIMER has been activated with the key E Filter alarm After 30h of operation the LED L2 turns RED It indicates that the grease filters need to be cleaned After 120h of operation the LED L2 turns RED and flashes It indicates that the grease filters need to be cleaned and the charcoal filters replaced After cleaning the grease filters and or replacing the charcoal filters restart the hour counter RESET by pressing the key E during display of the filter alarm CONTROLS Speed display PU5 ON OFF Motor 4lh speed PU4 ON OFF Motor 3rd speed PU3 ON OFF Motor 2nd speed PU2 ON OFF Motor 1a speed PU1 ON OFF Lights The hood purifies the air and evacuates it to the outside through an exhaust duct diameter 150 mm KEY LED

Скачать