Philips SERIES 1000 NT1150/10 [10/120] English

4 Move the comb over the eyebrow from the outer tip of the eyebrow

towards the base of the nose (against the direction of hair growth).

Cleaning

Clean the appliance immediately after use and when a lot of hair or dirt

has accumulated on the cutting element.

Never use compressed air, scouring pads, abrasive cleaning agents or

aggressive liquids such as petrol or acetone to clean the appliance.

Do not tap on the cutting element.

Do not use any sharp objects to clean the cutting element.

1 Make sure the appliance is switched off.

2 Rinse the cutting element of the nose/ear/eyebrow trimming head

with hot water.

3 Switch on the appliance and rinse the cutting element once more to

remove any remaining hairs. Then switch off the appliance again.

Tip: The best way to clean the cutting element is to immerse it in a glass with

warm water for a few minutes and then switch on the appliance.

4 NT5180, NT3160: Rinse the eyebrow combs with lukewarm water.

5 Let all parts dry completely before you use the appliance again.

Replacement

If the cutting element or combs (NT5180, NT3160 only) are damaged or

worn, always replace them with original Philips parts.

To buy accessories or spare parts, visit www.shop.philips.com/service

or go to your Philips dealer. You can also contact the Philips Consumer

Care Centre in your country (see the worldwide guarantee leaet for

contact details).

ENGLISH10