Makita KP312S [8/28] Operation

8

For the correct planer blade setting

Your planing surface will end up rough and uneven, unless the blade is set properly and securely. The blade must be

mounted so that the cutting edge is absolutely level, that is, parallel to the surface of the rear base.

Below are some examples of proper and improper settings.

Blade height adjustment (Fig. 8)

Blade height adjustment is usually not necessary. How-

ever, if you notice that the blade edge is below the level of

the rear base or protrudes too far from the rear base, pro-

When not in use, store the hex wrench as shown in the

figure to keep it from being lost.

cleaner operation, connect a vacuum cleaner to your

tool. To connect vacuum cleaner, remove the chip guide

from the tool. Place nozzle assembly and joint in its place

the start of planing, and at the back at the end of planing.

result in jamming by chips. For rough cutting, the depth of

cut can be increased, while for a good finish you should

reduce the depth of cut and advance the tool more

slowly.

Front roller (Fig. 14)

edge parallel to rear base line.

trudes too far in relation to rear