Clatronic EWB 3281 [35/55] Making ice cubes
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Clatronic EWB 3281 [35/55] Making ice cubes

Clatronic EWB 3281 [35/55] Making ice cubes
35
All other use is not intended and can cause
damages to the appliance and even injuries.
Clatronic International GmbH does not accept
liability for damages caused by unintended use.
Unpacking the device
Unpack the device.
Remove all packaging materials such as
foils, lling material, cable ties and cardboard
packaging.
Note:
The appliance may still be covered in some
residues from the manufacturing process.
Please clean the appliance as described in
chapter “Cleaning and Maintenance”.
Operation
Attention:
Please observe a waiting period of 2 hours
before initial operation and after moving the
appliance for the coolant to settle; otherwise
the compressor can be damaged.
Mains Power Connection
Be sure the voltage of the appliance (rating
plate) corresponds with the mains voltage
before connecting to mains power supply.
Connect the appliance to a properly installed
230V~ 50Hz wall outlet.
Making Ice Cubes
Note:
For hygienic reasons do not use the ice cubes
from the rst cycle.
Open the lid and remove the ice cube con-
tainer.
Fill the water tank with potable water (tap
water) to the MAX marking.
•
•
•
•
1.
2.
Replace the ice cube container and close the
lid.
Press SELECT to select the desired ice cube
size; the corresponding indicator lamp lights
up.
Press START to start the ice cube production.
The process takes between 9 and 13 minutes.
Keep the lid closed.
Note:
The production time depends on the set
ice cube size.
Depending on water/ambient temperature
the rst ice cubes come out a bit smaller.
During the next cycles the ice cubes get to
the set size.
The ice cube size depends on the ambient
temperature:
At 15°C ambient temperature we recom-
mend setting “S”; otherwise the ice
cubes may stick together, which can lead
to problems with the automatic scoop.
At 30°C ambient temperature we recom-
mend setting “L”.
Due to fast freezing the ice cubes can look
“milky”. This is the air trapped in the water
and does not inuence the quality of the
ice cubes.
Stop Ice Cube Production
Press STOP to stop ice cube production.
Note:
Before nally stopping the appliance automati-
cally empties the water tank and dissolves
already produced ice cubes.
Indicator Lamp READY
The temperature sensor stops the ice cube pro-
duction as soon as the ice cube container is full.
The indicator lamp READY lights up and a beep
tone sounds.
Remove the ice cubes with the supplied ice
cube scoop.
The indicator lamp READY turns off and a
few moments later ice cube production starts
again.
Indicator Lamp WATER REFILL
The indicator lamp turns on if the water tank is
nearly empty and a beep tone sounds. Ice cube
production is automatically halted.
3.
4.
5.
6.
•
•
•
-
-
•
•
•
Attention:
Only use potable water without additives!
Note:
The MAX marking is inside the water tank,
around the lower edge of the ice cube
container.
The water level must be below the ice
cube container.
Only use water at room temperature.
•
•
•
S = small, M = medium, L = large

Содержание

Похожие устройства

Скачать