Indesit IWSC 51052A — решение проблем с работой стиральной машины: советы и рекомендации [35/36]

Troubleshooting j inoesiT Your washing machine could fail to work Before contacting the Technical Assistance Centre see Assistance make sure that the problem cannot be solved easily using the following list Problem Possible causes Solutions The washing machine does not switch on The appliance is not plugged into the socket fully or is not making contact There is no power in the house The wash cycle does not start The washing machine door is not closed properly The ON OFF button has not been pressed The START PAUSE button has not been pressed The water tap has not been opened A delayed start has been set see Personalisation The washing machine does not take in water the indicator light for the first wash cycle stage flashes rapidly The water inlet hose is not connected to the tap The hose is bent The water tap has not been opened There is no water supply in the house The pressure is too low The START PAUSE button has not been pressed The washing machine continuously takes in and drains water The drain hose is not fitted at a height between 65 and 100 cm from the floor see Installation The free end of the hose is under water see Installation The wall drainage system is not fitted with a breather pipe If the problem persists even after these checks turn off the water tap switch the appliance off and contact the Assistance Service If the dwelling is on one of the upper floors of a building there may be problems relating to water drainage causing the washing machine to fill with water and drain continuously Special anti draining valves are available in shops and help to avoid this inconvenience The washing machine does not drain or spin The wash cycle does not include draining some wash cycles require the drain phase to be started manually The drain hose is bent see Installation The drainage duct is clogged The washing machine vibrates a lot during the spin cycle The drum was not unlocked correctly during installation see Installation The washing machine is not level see Installation The washing machine is trapped between cabinets and walls see Installation The washing machine leaks The water inlet hose is not screwed on properly see Installation The detergent dispenser drawer is blocked for cleaning instructions see Care and maintenance The drain hose is not fixed properly see Installation The option indicator lights and the start pause indicator light flash while one of the phase in progress indicator lights and the door lo cked indicator light will remain lit in a fixed manner Switch off the machine and unplug it wait for approximately 1 minute and then switch it back on again If the problem persists contact the Technical Assistance Service There is too much foam The detergent is not suitable for machine washing it should display the text for washing machines or hand and machine wash or the like Too much detergent was used GB 35