D-Link DGS-6608 — установка и подключение к управляемому коммутатору Ethernet [82/111]

Превью страниц Страница 82 / 111

DGS-6600 Layer 3 Chassis Ethernet Managed Switch Hardware Installation Guide

Command Line Interface through the Serial Ports

Users can also connect a computer or terminal to one of the serial console ports (USB or RS-232) to access the

Switch. The command line interface provides complete access to all Switch management features. The following

section provides details on how to setup this connection.

Connecting the Console Port

The DGS-6600-CM front panel provides two types of UART Console Interface, an RS-232 connector and a USB

connector. These two interfaces are mutually exclusive, with the USB interface having a higher priority. If the

Switch is currently being managed via the RS-232 console connection and a USB connection is established, the

CLI engine will use the USB connection and automatically disconnect the user who is connected to the Switch via

the RS-232 console connection.

Switching between the RS-232 and USB console connection is automatically controlled by the firmware.

However, this feature is disabled during system bootup. It is recommended that users do not make any changes

to the console connection interface during system bootup, as important bootup information may be missed.

In order to use the USB console interface the host will need to have a terminal emulation application (e.g., Hyper

Terminal, Teraterm etc.) installed and the correct USB driver for the Switch, which can be found on the CD-ROM

that was bundled with the Switch. You will need the following:

• A terminal with an RS-232 port, a computer with either an RS-232 or USB serial port and the ability to

emulate a terminal (Note: if you are using the USB port then the computer needs the USB driver from

the CD-ROM package installed).

• A console cable with a male DB-9 connector on one end and a female DB-9 connection at the other

end. This cable should be included with the Switch. It establishes the physical connection to the con-

sole port.

- or -

• A USB cable with a Type A connector and Type B connector at either end. This cable should be

included with the Switch. using the USB Type A/B connector it is possible to establish a physical con-

nection to the console port in a similar manner as using a RS-232 cable.

To connect a terminal to the console port:

Connect the female DB-9 connector on the console cable (shipped with the Switch) to the RS-232 serial port on

the computer running terminal emulation software then connect the male DB-9 connector to the RS-232 console

port on the front of the Switch.

- or -

Connect the Type A USB connector on the console cable (shipped with the Switch) to the USB serial port on the

computer running terminal emulation software then connect the Type B USB connector onto the USB console

port on the front of the Switch.

Set the terminal emulation software as follows:

• Select the appropriate serial port (COM port 1 or COM port 2).

• Set the data rate to 115200 baud.

• Set the data format to 8 data bits, 1 stop bit, and no parity.

• Set flow control to none.

• Under Properties, select VT100 for Emulation mode.