Ariens POWER BRUSH 28 [14/30] Long term

Ariens POWER BRUSH 28 [14/30] Long term
GB - 14
USING THE BRUSH
After proper Pre-Start and Starting:
1. Select speed control position and
direction.
IMPORTANT: DO NOT overload unit capacity
by sweeping at too fast a rate.
2. Engage the traction drive clutch first.
3. Engage the attachment clutch next.
Tips for Sweeping
To clear an area, run unit in an overlapping
series of paths. For large areas, start in the
middle and sweep debris to each side, so it is
not cleared more than once.
ALWAYS direct discharge away from area to
be cleared and with direction of the wind.
Snow is best removed as soon as possible
after snow fall.
TRAVELING
To travel from one work area to another:
1. Set throttle to SLOW position or slightly
higher.
2. Press down the handlebars enough to
raise the front of the unit slightly off the
surface.
3. Engage traction clutch without engaging
the attachment drive clutch.
TRANSPORT
ALWAYS shut off engine and close fuel shut-
off when transporting unit on a truck or trailer.
Use extra care when loading or unloading
unit onto trailer or truck.
Secure unit chassis to transport vehicle.
NEVER secure from rods or linkages that
could be damaged.
DO NOT transport machine while engine is
running.
SHORT TERM
IMPORTANT: NEVER spray unit with high-
pressure water or store unit outdoors.
Run unit a few minutes after each use to free
unit of any debris.
Inspect unit for visible signs of wear,
breakage or damage.
Keep all nuts, bolts and screws properly
tightened and know unit is in safe working
condition.
Store unit in a cool, dry protected area.
LONG TERM
Clean unit thoroughly with mild soap and low
pressure water and lubricate (see
Maintenance). Touch up all scratched painted
surfaces.
Remove weight from wheels by putting
blocks under frame or axle.
Fuel System
Gasoline left in the fuel system for extended
periods without a stabilizer will deteriorate,
resulting in gum deposits in the system.
These deposits can damage the carburetor
and the fuel hoses, filter and tank. Prevent
deposits from forming in the fuel system
during storage by adding a quality fuel
stabilizer to the fuel. Follow the
recommended mix ratio found on the fuel
stabilizer container.
To treat the fuel system for storage:
1. Add fuel stabilizer (Ariens p/n 00592900)
according to manufacturer’s instructions.
2. Run engine for at least 10 minutes after
adding stabilizer to allow it to reach the
carburetor.
NEVER store the engine with fuel in the fuel
tank inside of a building with potential
sources of ignition.
STORAGE
WARNING: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.

Содержание

Скачать