Dometic MAGICSAFE MSG 150 [14/196] Mounting the magicsafe msg150

Mounting the MagicSafe MSG150 MSG150

7 Mounting the MagicSafe MSG150

7.1 Tools required

For mounting you will require the following tools:

• Measuring ruler (fig. 1 1, page 3)

• Centre punch (fig. 1 2, page 3)

• Hammer (fig. 1 3, page 3)

• Drill bit set (fig. 1 4, page 3)

• Electric drill (fig. 1 5, page 3)

• Screwdriver (fig. 1 6, page 3)

7.2 Mounting the gas detector

Note the following when selecting a place to fit the gas detector:

• Note the length of the cable.

• The gas detector should be mounted in the vicinity of the sleeping area at the height of the

mattress.

➤ Select a suitable installation location.

➤ Hold the mounting panel on the chosen location and mark the two drill holes (fig. 5 , page 5).

➤ Screw the mounting panel tight with the two self-tapping screws (fig. 6, page 5).

➤ Insert the gas detector on the mounting panel (fig. 7, page 5).

➤ Insert the plug of the gas detector in the socket of your 12/24 Vg voltage supply.

✓ The green LED on the gas detector (fig. 8 1, page 5) flashes for approx. 10 min. The sensor is

then brought to the operating temperature.

When the green LED glows constantly, the gas detector is ready for operation.

8 Connecting the gas detector

8.1 As a single device

If you use the gas detector as a single device, you can either

• Switch it on with the 12/24 Vg plug

• Switch it on with the RV-AMP-SW additional switch (accessory), if there is no 12/24 Vg socket

in the sleeping area.

NOTICE!

Before making any drill holes, ensure that no electrical cables or other parts can be

damaged by drilling.

MSG150-IO-16s.book Seite 14 Freitag, 18. August 2017 8:35 08