Beurer UB 100 Инструкция по эксплуатации онлайн [12/52] 54019

Additional information UB 100

The area intended for the head

cannot be heated.

Guide the plug-in coupling plug

through the slot on the side section

[9] and then connect the switch to

the electric underblanket by plug-

ging together the plug-in coupling

[8] (see ﬁgure).

Then pull the side section over the sides of your mattress like a ﬁtted sheet. The electric under-

blanket is designed to ﬁt 90 x 200 cm as well as 100 x 200 cm mattresses. If the cable length is

insucient, you can order a longer power supply cord with the material number 108.424 from

our speciﬁed Customer Service. Then ﬁt your ﬁtted sheet as usual with the electric underblan-

ket positioned between your mattress and the ﬁtted sheet.

4.3 Switching on

Slide the ON/OFF switch [6] sideways [1] to the ON ( I ) position to switch on the electric under-

blanket.

When switched on, the display [2] lights up and at ﬁrst displays all the segments for approx. 2

seconds. After that, the following basic settings are displayed:

Temperature setting for body area: 0

Temperature setting for foot area: 0

Automatic switch-o time: 1 h (= 1 hour)

Note: The illuminance level drops after approx. 5 seconds so that your sleep is not disturbed

during the night.

Note: This electric underblanket has a rapid heating function, allowing for faster

warming in the ﬁrst 15 minutes. During this time, “Turbo” ﬂashes on the display.

If the underblanket is rapidly switched o and then on again during the ﬁrst 15 min-

utes, the fast heating function is deactivated for safety reasons.

In this case the word “Turbo” does not appear on the display. However the electric underblan-

ket is heated as normal.

To reactivate the fast heating function the electric underblanket must be completely switched

o for 20 minutes.

4.4 Switching o

Slide the ON/OFF switch to the OFF ( 0 ) position to switch o the electronic underblanket.

When switched o, the illumination and the display are turned o.

4.5 Setting the temperature

Press the button [3] to select the temperature setting for the body area.

Press the button [5] to select the temperature setting for the foot area.

Level 0: o

Level 1: minimum heat

Level 2 – 8: individual heat

Level 9: minimum heat

Note: Switching sequence of the temperature settings: 0 – 9 – 8 – 7 – 6 – 5 – 4 – 3 – 2 – 1 – 0 – 9 ...