Sharp SJ-642 NBE [12/12] What to do before you call for service

Sharp SJ-692 NBE [12/12] What to do before you call for service

/ Printed in Thailand

TINS-A985CBRZ 10ET TH

SHARP CORPORATION

CARE AND CLEANING

Some household cleaning chemicals may affect

the inside surfaces and plastic shelves resulting

in splitting or cracks occurring.

Evaporating pan & cover;

How to remove

1. Hold both sides of Evapo-

rating pan cover and an-

gling upward.

2. Pull Evaporating pan out.

How to set

1. Put Evaporating pan on

Radiator plate, then slide

it in completely.

2. Fit the pawls of Evaporat-

ing pan cover into the

holes of the cabinet, then

push the cover to attach.

NOTE:

• Do not use polishing powder, benzine, hot water etc.

• If undiluted detergent is used or soapy water is not

wiped off thoroughly, cracking of plastic parts can re-

sult.

• Wipe any food oils adhered to plastic components

as they can cause cracking of the plastic surface.

• The glass shelves weighs approximately 3kg each.

Hold firmly when removing from the cabinet or carry-

ing.

If you switch your refrigerator off when you are going away for

an extended period, remove all food, clean the interior thoroughly.

Remove the power cord plug from the power socket and leave

all doors open.

1. Remove the shelves and pockets from the cabinet

and door. Wash them in warm soapy dishwashing

water; rinse in clean water and dry.

2. Clean the inside with a cloth soaked in warm soapy

dishwashing water. Then, use cold water to wipe off

soapy water.

3. Wipe the exterior with a soft cloth each time it is

soiled.

4. Clean Magnetic door seal with a toothbrush and

warm soapy dishwashing water.

5. Evaporating pan should be removed and cleaned

once a year.

When cleaning all plastic parts in-

side this refrigerator, only use di-

luted dishwashing liquid(soapy

water). Make sure that all plastic

parts are thoroughly rinsed with

water after cleaning.

Switching off your refrigerator

WHAT TO DO BEFORE YOU CALL FOR SERVICE

Evaporating pan

cover

Hole

Pawl

Before you call for service, check the following point.

IT IS NORMAL for the refrigerator to produce the

following sounds.

• Loud noise produced by the compressor when op-

eration starts --- Sound becomes quieter after a while.

• Loud noise produced once a day by the compressor

--- Operating sound produced immediately after au-

tomatic defrost operation.

• Sound of flowing fluid (gurgling sound, fizzing sound)

--- Sound of refrigerant flowing in pipes (sound may

become louder from time to time).

• Cracking or crunching sound --- Sound produced by expan-

sion and contraction of inner walls and internal parts during

cooling.

• Squeaking sound --- Sound produced by expansion and con-

traction of internal parts.

IT IS NORMAL that the outside of a cabinet may be hot when

touched. The hot pipe is in the cabinet in order to prevent dew

generation.

IF YOU STILL REQUIRE SERVICE

Refer to your nearest service agent approved by SHARP.

Replacing method of the lamp bulb

1. Unplug the refrigerator first to prevent electric shock.

2. Remove the light cover.

3. Replace the lamp bulb with the same type.

Freezer: base E12, MAX 10W, T-20

Refrigerator: base E12, MAX 15W, T-20

Light cover

Напечатано в Таиланде

Sharp SJ-642 NBE [12/12] What to do before you call for service

Содержание

Похожие устройства