Weldy MINIWELDER GEO2 (154.880) [9/96] Operating instructions

Please read operating instructions carefully before use

and keep for further reference.

Operating instructions (Original operating instructions)

WELDY miniwelder

Automatic Welder

DANGER!

Danger when opening up the tool, as components and connections are ex-

posed. Therefore, before opening it, unplug the tool to ensure disconnection

from the mains.

Danger of fire and explosion! Incorrect use of the automatic welder (e.g.

overheating of the

material) can present a ﬁ re and explosion hazard, especially near

combustible materials and explosive gases.

Danger – can cause burns! Do not touch bare metal parts and emerging

material while hot. Allow the device to cool down.

Warning

The tool must be operated under supervision. Heat can ignite flammable

materials which are not in view. The machine may only be used by qualified

specialists or under their supervision. Children are not authorized to use

this machine.

For personal protection on building sites we strongly recommend the tool be

connected to a RCCB (Residual Current Circuit Breaker).

Protect tool from damp and wet.

Caution

The voltage rating stated on the tool must correspond to the mains voltage.

In case of a power loss, the potentiometer drive speed (12) and potentiometer

heating (15) had to be set to 0.

230

400

Only connect the tool to a receptacle with protective earth conductor. Any dis-

connection of the protective earth conductor, in or outside the tool is dangerous!

Use line/mains extension cables with protective earth /ground conductor

and adequate cross sectional area only!

While working on the open system avoid wearing garments such as shawls,

scarves and ties. Long hair must be tied or protected by headgear.

Moving parts may not be touched. The danger exists of inadvertently becoming

caught and being pulled in.