Ryobi RBL26BP (3001815) [20/298] English original instructions

Ryobi RBL26BP (3001815) [20/298] English original instructions
18
English (Original instructions)
ADJUSTING THE HARNESS AND CHEST STRAPS
CAUTION
Make all adjustments to the harness straps before
starting the blower to avoid the possibility of injury.
To adjust harness strap assembly:
The blower should be in operating position before
adjusting the harness straps. Slip your arm through
the harness strap and onto your shoulder, then repeat
for the other shoulder.
There are two possible height adjustment positions
that can be used to easily adjust the harness.
Slip top buckle of the harness from adjustment slot and
position to your desired height location.
Tighten (pull down on strap) or loosen (lift up the tab of
the strap buckle) each harness strap as needed, until
each is adjusted to a comfortable operating position.
The chest strap should be tightened or loosened until
adjusted to a comfortable operating position.
To adjust waist strap assembly:
The waist strap should be tightened or loosened until
adjusted to a comfortable operating position.
OPERATION
WARNING
Petrol is extremely flammable and explosive. A fire or
explosion from petrol will burn you and others.
MIXING THE FUEL
See Fig. 3.
The product is powered by a 2-stroke engine and
requires pre-mixing petrol and 2-stroke oil. Pre-mix
unleaded petrol and 2-stroke engine oil in a clean
container approved for petrol.
The engine is certified to operate on unleaded petrol
intended for automotive use with an octane rating of
91 ([R + M] / 2) or higher.
Do not use any type of pre-mixed petrol/oil from fuel
service stations, this includes the pre-mixed petrol/oil
intended for use in mopeds, motorcycles, etc.
Use synthetic 2-stroke oil only. Do not use automotive
oil or 2-stroke outboard oil.
Mix 2% synthetic 2-stroke into the petrol. This is a 50:1
ratio.
Mix the fuel thoroughly and also each time before
refuelling.
Mix in small quantities. Do not mix quantities larger
than usable in a 30-day period. Synthetic 2-stroke oil
containing a fuel stabilizer is recommended.
1 L + 20 mL =
}
2 L + 40 mL =
3 L + 60 mL = 50:1
4 L + 80 mL =
5 L + 100 mL =
FILLING THE TANK
Clean surface around fuel cap to prevent
contamination.
Loosen the fuel cap slowly to release pressure and to
keep the fuel from escaping around the cap.
Carefully pour the fuel mixture into the tank. Avoid
spillage. Prior to replacing the fuel cap, clean and
inspect the gasket.
Immediately replace the fuel cap and hand tighten.
Wipe away any fuel spillage. Move 9m away from
refuelling site before starting engine.
NOTE: It is normal for smoke to be emitted from a new
engine during and after first use.
WARNING
Always shut off engine before fuelling. Never add fuel to
a machine with a running or hot engine. Move at least
9 m from refuelling site before starting engine. Do not
smoke!

Содержание

Скачать