Biostar X370GTN Версия 5.x [32/72] Raid functions

32 | Chapter 4: Useful help

CPU Overheated

If the system shutdown automacally aer power on system for seconds, that means the CPU

protecon funcon has been acvated.

When the CPU is over heated, the motherboard will shutdown automacally to avoid a

damage of the CPU, and the system may not power on again.

In this case, please double check:

1. The CPU cooler surface is placed evenly with the CPU surface.

2. CPU fan is rotated normally.

3. CPU fan speed is fullling with the CPU speed.

Aer conrmed, please follow steps below to relief the CPU protecon funcon.

1. Remove the power cord from power supply for seconds.

2. Wait for seconds.

3. Plug in the power cord and boot up the system.

Or you can:

1. Clear the CMOS data. (See “Close CMOS Header: JCMOS1” secon)

2. Wait for seconds.

3. Power on the system again.

4.4 RAID Functions

RAID Denions

In a RAID 0 system data are split up in blocks that get

wrien across all the drives in the array. By using mulple

disks (at least 2) at the same me, this oers superior I/O

performance. This performance can be enhanced further by

using mulple controllers, ideally one controller per disk.

Features and Benets

• Drives: Minimum 2, and maximum is up to 6 or 8. Depending on the plaorm.

• Uses: Intended for non-crical data requiring high data throughput, or any environment

that does not require fault tolerance.

• Benets: provides increased data throughput, especially for large les. No capacity loss

penalty for parity.

• Drawbacks: Does not deliver any fault tolerance. If any drive in the array fails, all data is

lost.

• Fault Tolerance: No.

• Total Capacity: (Minimal. HDD Capacity) x (Connected HDDs Amount)