Cecotec Conga 5090 Cyclone [30/90] Before use

ENGLISH

3. BEFORE USE

• Take the product out of the box and remove all packaging material.

• Make sure all parts and components are included and in good conditions. If any visible

signs of damage are observed, contact the Technical Support Service immediately.

4. INSTALLATION

Robot and charging base installation

1. Connect the charging base to a power supply and store the

remaining cable. It is important to store the remaining cable

at the bottom of the charging base to avoid it from being

dragged and disconnected.

2. Place the charging base against the wall, leaving the

safety distance indicated in the below picture.

WARNING: Do not expose the charging base to direct sun light.

3. Long press the button for 3 seconds; when the light

indicator turns on, place the robot on the charging base.

• Steady blue light: ON/operating

• Orange light blinks: charging

• Red light blinks: error

Note:

• Take the robot to the charging base if the battery is low. The robot might not turn on if the

battery is very low.

• The robot will automatically turn on when placed on the charging base.

• The robot cannot be turned off during charging.