Cecotec Conga 5090 Cyclone [40/90] Cleaning and maintenance

ENGLISH

to clean a specic area in zigzag motion. The robot will clean the selected area and then will

return directly to the charging base. You can set more than 1 area at the same time. The robot

will only clean the area selected in the map, therefore it will go to the point and return to the

base without vacuuming.

It can only be activated from the App.

8. Spot mode: Select this mode if you want to clean thoroughly a specic point in the map,

making the most of the robot’s maximum power. The robot will clean a 2x2 m zone in zigzag

motion and then will return directly to the charging base when cleaning is completed. The

robot will only clean the area selected on the map, therefore it will go to the point and return

to the base without vacuuming.

It can only be activated from the App.

9. Restricted Area mode: Select this mode and delimit in the map specic areas where you

do not want the robot to clean. You can set more than 1 restricted area at the same time on the

map.

It can only be activated from the App.

10. Twice mode: Use this mode to carry out a deep, thorough cleaning of your home. It can be

combined with Edge, Spiral, Spot or Smart Area modes. The robot will carry out 2 full cleaning

cycles and then will return directly to the charging base.

7. CLEANING AND MAINTENANCE

Main brush

1. Turn the robot around and press the main brush’s release button to take the cover

out.

2. Take the main brush out and clean the compartment.

3. Clean the main brush with the provided tools and use water and soap if necessary.

4. Place the main brush in its position and fasten the cover’s clip.

Note: Replace the main brush every 6-12 months to ensure efcient operating (depending on

the frequency and type of use).

1. Main brush cover

2. Tab

3. Main brush

4. Compartment