Icom IC-T7H [19/36] Advanced functions

ADVANCED FUNCTIONS

D Programming during selection

➀ Push [VFO] to select VFO mode.

➁ Set the desired frequency:

➥ Set other data, such as re-

peater information, etc. using

set mode if required.

➂ Push [S.MW] momentarily.

•“X” ﬂashes.

• Do not hold [S.MW] for more than 1

sec., otherwise the memory channel

will overwrite the displayed number.

➃ Rotate [DIAL] to select the desired

channel.

• Call channel and scan edge channels,

as well as regular memory channels,

can be programmed in this way.

• If you want to confirm the VFO fre-

quency, push [S.MW] momentarily.

➄ Push [S.MW] for 1 sec. to program.

•“X” stops ﬂashing.

LOW

■

Memory/call channels

The transceiver has 70 memory channels (60 regular, 4 pairs

of scan edge channels for mixed bands and 1 call channel for

each band). Note that memory channels are not grouped ac-

cording to band. In other words, a given memory channel can

be programmed with either a VHF frequency or a UHF fre-

quency. This is not the case with call channels. Call channels

are band speciﬁc.

The following can be programmed into memory/call channels:

• Operating frequency

• Duplex direction with an offset frequency (pgs. 13, 14)

• Subaudible tone encoder or tone squelch ON/OFF with a

tone (CTCSS) frequency (pgs. 21, 22)

• Skip information (p. 20)