Icom IC-M302 [6/48] Precaution

New2001

PRECAUTION

RWARNING! NEVER connect the transceiver to an AC

outlet. This may pose a fire hazard or result in an electric

shock.

CAUTION: Changes or modiﬁcations to this device, not ex-

pressly approved by Icom Inc., could void your authority to

operate this device under FCC regulations.

NEVER connect the transceiver to a power source of more

than 16 V DC or use reverse polarity. This will ruin the trans-

ceiver.

NEVER cut the DC power cable between the DC plug and

fuse holder. If an incorrect connection is made after cutting,

the transceiver may be damaged.

NEVER place the transceiver where normal operation of the

vessel may be hindered or where it could cause bodily injury.

KEEP the transceiver at least 3.3 ft (1 m) away from the

ship’s navigation compass.

DO NOT use or place the transceiver in areas with temper-

atures below –4°F (–20°C) or above +140°F (+60°C) or, in

areas subject to direct sunlight, such as the dashboard.

AVOID the use of chemical agents such as benzine or al-

cohol when cleaning, as they may damage the transceiver

surfaces.

BE CAREFUL! The transceiver rear panel will become

hot when operating continuously for long periods.

Place the transceiver in a secure place to avoid inadvertent

use by children.

BE CAREFUL! The transceiver employs waterproof con-

struction, which corresponds to JIS waterproof speciﬁcation,

Grade 7 (1 m/30 min.). However, once the transceiver has

been dropped, waterproofing cannot be guaranteed due to

the fact that the case may be cracked, or the waterproof seal

damaged, etc.

!IC-M302-1.qxd 03.10.27 9:06 AM Page v (1,1)