Viking MA 443 [55/337] General
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Viking MA 443 [55/337] General

Viking MA 443 [55/337] General
53
DEFRNLITESPTNOSVDAELRU EN
0478 131 9922 C - EN
13.1 General
Annual service by the specialist dealer:
The lawn mower should be inspected once
annually by a specialist dealer. VIKING
recommends VIKING specialist dealers.
13.2 Cleaning the machine
Maintenance interval:
After each use
● Only clean the machine using water,
with a brush or with a cloth. Remove
accumulated clipping deposits using a
stick. If necessary, use a special
cleaner (e.g. STIHL special cleaner).
● Never spray water or high pressure
cleaners onto batteries, switches, motor
components, seals or bearing points.
Cleaning position, MA 443:
● Detach the grass catcher box. (Ö 9.5)
● Hold the upper handlebar (1) and open
the quick-clamping devices – fold
downwards.
● Set down the upper handlebar (1)
rearwards.
● Open the discharge flap (2) and hold it
open.
● Lift up the machine at the front and
place in the cleaning position as shown.
Check that the machine is stable.
Cleaning position, MA 443 C:
● Detach the grass catcher box. (Ö 9.5)
● Open the discharge flap (2) and hold it
open.
● Press the detent lever (3) downwards
with the thumb and hold.
● Hold the machine at the front
handle and tilt it slowly rearwards.
● Release the discharge flap (2) and
check that the machine is standing
securely.
13.3 Electric motor and wheels
The electric motor is maintenance-free.
The wheel bearings are maintenance-free.
13.4 Battery
Maintenance interval:
Before each use
Visually check that the battery is
undamaged. Batteries with identifiable
damage (e.g. cracks or escaping fluid),
must not be used.
13.5 Charger
Maintenance interval:
Before each use
Check electric cable for damage and
ensure that cooling air slots are free of dirt.
13.6 Mowing blade maintenance
Maintenance interval:
Before each use
● Tilt the mower upwards into the
cleaning position. (Ö 13.2)
● Clean the mowing blade (1) and check
it for damage (notches or cracks) and
wear; replace if necessary.
● Use a slide calliper (not included in
standard equipment) to measure blade
thickness at 5 points at least. In
particular, the minimum thickness must
also be ensured in the area of the blade
wings.
● Place a ruler (2) against the front blade
edge and measure permissible
grinding.
13. Maintenance
Risk of injury!
Observe the safety instructions in
the section "For your safety" (Ö 4.).
Remove the safety plug,
particularly before
performing any work on the lawn
mower (Ö 9.1).
Risk of injury!
Before tipping up the mower, place
it on firm, level and flat ground. The
machine may tip over when working
on it in the cleaning position.
Always stand to the side of the
machine. Never work in front of or
behind the mower.
22
To facilitate cleaning work, it is
recommended to select the highest
cutting level before placing the
machine in the cleaning position.
Danger of pinching!
After actuation of the detent lever,
the upper handlebar can fall to the
lowest position under its own
weight.
Never place your finger between
the handlebar and the handlebar
console (under the detent lever).
23

Содержание

Похожие устройства

Скачать