Korting OKB9113CFX Инструкция по эксплуатации онлайн [36/44] 71164

Oven cavity light

When the oven starts operating in one of the cooking functions, the oven light is on, and will turn off

automatically after 5 minutes.

Every time when the light turns off, it can be reactivated for 5 minutes by pressing the keys “+” (3) or “-“ (6)

or the key (5), or the key (4).

If the oven is in “Wait to Start” mode, the oven light is off.

Preheating bar-graph

The bar shows the preheating status of the oven.

Start: 1st flashing; 2d, 3d, 4th off

If >25%: 1st on, 2d flashing; 3d, 4th off

If >50%: 1st, 2d on; 3d flashing; 4th off

If >75% 1st, 2d, 3d on; 4th flashing

If 100%: 1st, 2d, 3d, 4th on

At the end of preheating, the bar-graph is always fully on: 1st, 2d, 3d, 4th on.

When a cooking function is in progress (after the preheating is reached), the temperature in the oven cavity

can fall below the set level: if it is more than 15°C lower. The bar progressively turns off following the same

scheme of the preheating.

Tangential fan

The tangential fan turns on, no matter which is the cavity temperature, after 15 minutes of the oven

functioning, or even before, if the cavity temperature is > 130°C.

The tangential fan turns off, no matter which is the cavity temperature, 25 minutes after the oven has been

turned off, or even before if the cavity temperature is < 120°C.

How to cancel a programmed coking mode

In order to cancel any programmed cooking mode, press together the keys “+” (3) and “-“ (6), while in editing

one of these two parameters: the oven goes to Manual Cooking Mode.

Alternatively, it’s possible to fully turn the oven off and on again, by pressing the key (4).

How to cancel a programmed Timer mode

In order to cancel any Timer setting, press together the keys “+” (3) and “-“ (6), while in editing the Timer.

How to change the current sound level

There are 3 volume and frequency levels that can be selected: low, medium and high.

When the oven is in stand-by (OFF), press the key (5) 3 times. The Timer display shows “Lx”. (1=low,

2=medium, 3=high). Select the volume by using the keys “+” (3) or “-“ (6).

A beep will be heard at the currently selected value, and the new volume level will be memorized and used

for any new acoustic signal.