![Nissan Note [6/52] Gasoline engine premium gasoline](/img/pdf.png)
Nissan Note [6/52] Gasoline engine premium gasoline
![Nissan Note [6/52] Gasoline engine premium gasoline](/views2/1789816/page6/bg6.png)
GI-6
PRECAUTIONS
CAUTION:
Do not use leaded gasoline. Using leaded gasoline will damage the three way catalyst.
● Except for the above models ... use unleaded or leaded gasoline with an octane rating of at least 88 RON
(research octane number).
Use unleaded gasoline if instructed on the fuel filler lid.
GASOLINE ENGINE (PREMIUM GASOLINE)
Use premium unleaded gasoline with an octane rating of at least 95 RON (research octane number). If pre-
mium unleaded gasoline is not available, regular unleaded gasoline with an octane rating of at least 91 RON
(research octane number) can be used. However, for maximum vehicle performance, the use of premium
unleaded gasoline is recommended.
CAUTION:
Do not use leaded gasoline. Using leaded gasoline will damage the three way catalyst. Using a fuel
other than that specified could adversely affect the emission control devices and systems, and could
also affect the warranty coverage validity.
DIESEL ENGINE
● For Europe model; use diesel fuel of at least 50 cetane.
● Except for Europe model; use diesel fuel of at least 45 cetane.
If two types of diesel fuel are available, use summer or winter fuel properly according to the following temper-
ature conditions.
● Above -7°C(20°F) ··· Summer type diesel fuel.
● Below -7°C(20°F) ··· Winter type diesel fuel.
CAUTION:
● Do not use home heating oil, gasoline or other alternate fuels in your diesel engine. The use of
those can cause engine damage.
● Do not use summer fuel at temperature below -7°C(20°F). The cold temperature will cause wax to
form in the fuel. As a result, it may prevent the engine from running smoothly.
● Do not add gasoline or other alternate fuels to diesel fuel.
Precautions for Multiport Fuel Injection System or Engine Control System
BAS0002K
● Before connecting or disconnecting any harness connector for
the multiport fuel injection system or ECM:
Turn ignition switch to “OFF” position.
Disconnect negative battery terminal.
Otherwise, there may be damage to ECM.
● Before disconnecting pressurized fuel line from fuel pump to
injectors, be sure to release fuel pressure.
● Be careful not to jar components such as ECM and mass air
flow sensor.
Precautions for Turbocharger (If Equipped)
BAS0002L
The turbocharger turbine revolves at extremely high speeds and
becomes very hot. Therefore, it is essential to maintain a clean sup-
ply of oil flowing through the turbocharger and to follow all required
maintenance instructions and operating procedures.
● Always use the recommended oil. Follow the instructions for
proper time to change the oil and proper oil level.
● Avoid accelerating engine to a high rpm immediately after start-
ing.
● If engine had been operating at high rpm for an extended period
of time, let it idle for a few minutes prior to shutting if off.
SGI787
SGI292
Содержание
- A general information 1
- Contents 1
- General information 1
- Sectio 1
- Description 3
- Maintenance information 3
- Precautions 3
- Precautions for nats nissan anti theft system 3
- Precautions for supplemental restraint system srs air bag and seat belt pre tensioner 3
- Rhd models 3
- General precautions 4
- Lhd models 4
- Precautions 4
- Precautions for procedures without cowl top cover 4
- Gasoline engine regular gasoline 5
- Precautions 5
- Precautions for fuel 5
- Precautions for three way catalyst 5
- Diesel engine 6
- Gasoline engine premium gasoline 6
- Precautions 6
- Precautions for multiport fuel injection system or engine control system 6
- Precautions for turbocharger if equipped 6
- Health protection precautions 7
- Hose clamping 7
- Hose removal and installation 7
- Precautions 7
- Precautions for engine oils 7
- Precautions for hoses 7
- Environmental protection precautions 8
- Precautions 8
- Precautions for air conditioning 8
- Contents 9
- Description 9
- How to use this manual 9
- Relation between illustrations and descriptions 10
- Components 11
- How to use this manual 11
- Symbols 11
- The large illustrations are exploded views see the following and contain tightening torques lubrication points section number of the parts catalog e g sec 440 and other information nec essary to perform repairs the illustrations should be used in reference to service matters only when ordering parts refer to the appropriate parts catalog components shown in an illustration may be identified by a circled number when this style of illustration is used the text description of the components will follow the illustration 11
- Description 12
- How to follow test groups in trouble diagnoses 12
- How to follow trouble diagnoses 12
- How to use this manual 12
- Harness wire color and connector number indication 13
- How to use this manual 13
- Type 1 harness wire color and connector number are shown in illustration 13
- How to use this manual 15
- Connector symbols 16
- How to read wiring diagrams 16
- How to use this manual 16
- For detail refer to following description 17
- How to use this manual 17
- Sample wiring diagram exampl 17
- Description 18
- How to use this manual 18
- Optional splice 18
- How to use this manual 19
- Component indication 20
- Harness indication 20
- How to use this manual 20
- Switch positions 20
- A line with less weight thinner line represents a non detect able line for dtc a non detectable line for dtc is a circuit in which ecm cannot detect its malfunctions with the on board diagnostic system 21
- A line with regular weight wider line represents a detectable line for dtc diagnostic trouble code a detectable line for dtc is a circuit in which ecm can detect its malfunctions with the on board diagnostic system 21
- Detectable lines and non detectable lines 21
- How to use this manual 21
- In some wiring diagrams two kinds of lines representing wires with different weight are used 21
- How to use this manual 22
- Multiple switch 22
- Abbreviations 23
- How to use this manual 23
- Reference area 23
- The following abbreviations are used 23
- The reference area of the wiring diagram contains references to additional electrical reference pages at the end of the manual if connector numbers and titles are shown in the reference area of the wiring diagram these connector symbols are not shown in the connector area 23
- How to use this manual 24
- How to perform efficient diagnosis for an electrical incident 25
- Incident simulation tests introduction 25
- Service information for electrical incident 25
- Sometimes the symptom is not present when the vehicle is brought in for service if possible re create the conditions present at the time of the incident doing so may help avoid a no trouble found diagnosis the fol lowing section illustrates ways to simulate the conditions environment under which the owner experiences an electrical incident the section is broken into the six following topics 25
- Vehicle vibration 25
- Work flow 25
- Service information for electrical incident 26
- Vehicle vibration 26
- Electrical load 27
- Freezing 27
- Heat sensitive 27
- Service information for electrical incident 27
- Water intrusion 27
- Circuit inspection introduction 28
- Cold or hot start up 28
- Service information for electrical incident 28
- Testing for opens in the circuit 28
- Service information for electrical incident 29
- Testing for shorts in the circuit 29
- Ground inspection 30
- Service information for electrical incident 30
- Voltage drop tests 30
- Service information for electrical incident 31
- Control unit circuit test 32
- Input output voltage chart 32
- Service information for electrical incident 32
- System description when the switch is on the control unit lights up the lamp 32
- Control units and electrical parts 33
- Precautions 33
- Service information for electrical incident 33
- Service information for electrical incident 34
- Smj installation 34
- Consult ii checking system 35
- Consult ii contains a nickel metal hydride battery when replacing the battery obey the following warning replace the nickel metal hydride battery with genuine consult ii battery only use of another bat tery may present a risk of fire or explosion the battery may present a fire or chemical burn hazard if mistreated do not recharge disassemble or dispose of in fire keep the battery out of reach of children and discard used battery conforming to the local regulations 35
- Consult ii is a hand held type tester when it is connected with a diagnostic connector equipped on the vehicle side it will communicate with the control unit equipped in the vehicle and then enable various kinds of diagnostic tests 35
- Description 35
- Function and system application 35
- Nickel metal hydride battery replacement 35
- Refer to consult ii software operation manual for more information 35
- Checking equipment 36
- Consult ii checking system 36
- Consult ii start procedure 36
- Consult ii checking system 37
- Select the desired part to be diagnosed on the select diag mode screen 37
- Touch necessary system on select system screen if necessary system is not indicated check power supply and ground of system control unit if it is normal refer to gi 38 consult ii data link connector dlc circuit 37
- Consult ii checking system 39
- If the consult ii cannot diagnose the system properly check the following items 39
- Inspection procedure 39
- Note the ddl1 and ddl2 circuits from dlc pins 12 13 14 and 15 may be connected to more than one system a short in a ddl circuit connected to a control unit in one system may affect consult ii access to other sys tems 39
- Commercial service tools 40
- Garage jack safety stand and 2 pole lift 40
- Lifting point 40
- Board on lift 41
- Caution make sure vehicle is empty when lifting 41
- Lifting point 41
- Position attachments at front and rear ends of board on lift 41
- The board on lift attachment set at front end of vehicle should be set on the front of the sill under the front door opening 41
- Tow truck towing 42
- Towing an automatic transaxle model with four wheels on ground 42
- Vehicle recovery freeing a stuck vehicle 42
- Recovery hook is not available 43
- Tow truck towing 43
- Tightening torque of standard bolts 44
- Tightening torque table 44
- Identification information 45
- Model variation 45
- Prefix and suffix designations 45
- Engine serial number cr engine 47
- Engine serial number hr engine 47
- Identification information 47
- Identification plate 47
- A engine type 48
- Automatic transaxle number 48
- B engine type approval letter 48
- D renault code 48
- Dimensions 48
- E engine suffix 48
- Engine identification k9k engine 48
- F engine fabrication number 48
- G engine assembly plant 48
- Identification information 48
- Identification is engravfd on the cylinder block which carries 48
- Wheels tyres 48
- All emission related terms used in this publication in accordance with iso 15031 2 are listed accordingly new terms new acronyms abbreviations and old terms are listed in the following chart 49
- Iso 15031 2 terminology list 49
- Terminology 49
- Terminology 50
- Terminology 51
- Terminology 52
Похожие устройства
- Nissan Note INSTRUMENT PANEL
- Nissan Note ENGINE LUBRICATION SYSTEM
- Nissan Note GLASSES, WINDOW SYSTEM _ MIRRORS
- Nissan Note LAN SYSTEM
- Nissan Note LIGHTING SYSTEM
- Daikin BRC1H81W7 Инструкция по эксплуатации
- Nissan Note REAR AXLE
- Nissan Note REAR SUSPENSION
- Nissan Note POWER STEERING SYSTEM
- Nissan Note SEAT
- Nissan Note STEERING CONTROL SYSTEM
- Nissan Note MANUAL TRANSAXLE
- Nissan Note MAINTENANCE
- Daikin BRC1H81W7 Руководство по применению для установщика
- Nissan Note SUPPLEMENTAL RESTRAINT SYSTEM _SRS_
- Nissan Note STARTING _ CHARGING SYSTEM
- Nissan Note POWER SUPPLY, GROUND _ CIRCUIT ELEMENTS
- Nissan Note ROAD WHEELS _ TYRES
- Nissan Note WIPER, WASHER _ HORN
- Daikin BRC1H81S7 Инструкция по эксплуатации
Скачать
Случайные обсуждения